hitman
08-25-2010, 12:09 PM
2 walbro 255 fuel pumps for s14 , used. this way you can have a back up. one just off my car other was back up.
both for 55$
ls auto axles, its just the center peice that is strengthened and you run them with stock cv's. good for about 400hp. one side comes assembled with the cv's and the other side is just the shaft.
100$
s14 fuel tank
25$
rb25 trans setup (no trans). just bell housing, shifter, driveshaft, slave cylinder, crossmember, and a clutch. everything you need to put an rb25 or z32 (think its the same) tranny on your setup, but the actual tranny.
i modified the bell housing, shifter and slave cylinder is oem nissan, driveshaft was made, crossmember made at part shop max, clutch is an orc single disk w/ flywheel(all parts used).
$500
gt3071 turbo w/ t3 flange and /63 ar. used this on my setup last year, been holding onto it as a back up for this year but am now ready to sell it.
$550
hollar, stuff is priced to move
[email protected]
i can text you photos if you have something specific you want to see.
both for 55$
ls auto axles, its just the center peice that is strengthened and you run them with stock cv's. good for about 400hp. one side comes assembled with the cv's and the other side is just the shaft.
100$
s14 fuel tank
25$
rb25 trans setup (no trans). just bell housing, shifter, driveshaft, slave cylinder, crossmember, and a clutch. everything you need to put an rb25 or z32 (think its the same) tranny on your setup, but the actual tranny.
i modified the bell housing, shifter and slave cylinder is oem nissan, driveshaft was made, crossmember made at part shop max, clutch is an orc single disk w/ flywheel(all parts used).
$500
gt3071 turbo w/ t3 flange and /63 ar. used this on my setup last year, been holding onto it as a back up for this year but am now ready to sell it.
$550
hollar, stuff is priced to move
[email protected]
i can text you photos if you have something specific you want to see.