View Full Version : removing drawer from craftsman toolbox
shiftin_sideways
06-20-2010, 03:30 PM
I own a craftsman toolbox. It is one of the larger ones(about 3-4ft tall). It has ball bearing slides and griplatch handles. One of the wheels fell off and I want to put it back on. I can't put on the nut to the bolt without removing one of the drawers. Can you guys also provide pictures? Any help would be greatly appreciated.
theicecreamdan
06-20-2010, 04:32 PM
Slide the drawer all the way out, now slide it back in about 1/4". There are little tabs that press in from inside the drawer into the slides. You need to go to the outside of the drawer slide and push a screwdriver through and push the tab back towards the middle a little bit. after that it should slide all the way out easily.
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.