Ls2 s13 hatch need opinions

[mikulec240]

do you guys think i will need a whole new rear end to it or with the s13 one hold up?
upgrading full brembos and gonna need full suspension anyone have any ideas?
still looking for an s14 shell if anyone has a clean one

[g6civcx]

Durability will be fine, but the 4.083 may be too much gear.

[mikulec240]

well i can get a gto rear end with the engine.. jsut dont know if it will fit on there
because it is gonan be a lot of power

[g6civcx]

Look at the subframe. Look at the GTO diff. See what you think.

Until you break 700-800 ft-lbs on big slicks, the diff will hold up. The axles/driveshafts will break before the diff will.

[lazysk8er2]

http://i17.photobucket.com/albums/b81/BRAAPZ/Rusch%20Motorsports/motivator1789543.jpg

[ak_slick]

R200 will be fine. Axles might break. There is any easy replacement with a z32tt axle and a q45 axle that has been used up to around 700-800 ft-lbs with no problems. Check on ka-t.


If you need to swap ring and pinion of the r200 there are TONS of options. All the way down to a 3.53 iirc.

[Slammed Assassin]

welded diffs will hold. id just get beefy axles.

[g6civcx]

If you need to swap ring and pinion of the r200 there are TONS of options. All the way down to a 3.53 iirc.

3.133 is as low as you can go without custom.