rhd without front clip

[bonezdebomb]

is it possible to do a rhd conversion without a front clip, myabe just cut a section out of a jdm firewall and use it to rplace the usdm firewall. i know i need the dash steering colum p/s rack, do i need the brake booster and pedals or are the the same

[soreballz]

Why would you want to do this? Is the drive-thru at your favorite burger joint on the right side of the building?

[battle_240sx]

dont do it. i did one in like 2005 and it was good on the inside but looked like butt in the engine bay. if you are gonna do one do it the right way and you will save time and money. if you are askin what u need to do one then you should pay to have one done and dont do it yourself

[bonezdebomb]

ok thanks i just wanted to know if anyone has done it that way and how it turned out. by the way do you know where i could pick up a good front clip for an s14

[miravete]

you can use the brake booster and clutch cylinder thing from your own car. you just need to cut the lines, bend them, and make the new ends.

pedals are slightly diff too but you can use your own.

heres where i buy my jdm stuff:)

JPR Motor Inc. (http://www.jprmotorinc.com/)

[5pecialist]

Is the drive-thru at your favorite burger joint on the right side of the building?
It would definitely come in handy for older In & Out Burgers, or Rally/Checkers on the East coast :naughty:

[bonezdebomb]

thanks are theyre front clips in good enough condition for a swap

[miravete]

thanks are theyre front clips in good enough condition for a swap

jpr has very good swaps :)