need help with wide quarter panel

[wacko2]

hey i have s13 coupe want put wide quarter panel 30mm, do i have do somethin to the rear like cute the quarter panel if im goin 30 mmm, been look online see any has anyone done the rear, need help with it,

[g6civcx]

Why are you putting on wide fenders? Cosmetic or clearance?

If cosmetic then it's your choice.

If clearance then you will have to cut.

[GSXRJJordan]

Agreed. I did a writeup on what to cut years ago, I'm sure you can find it by searching my username with cut and quarterpanel.

[godrifttoday]

pulling teeth!
http://i49.tinypic.com/25pshft.jpg
http://i49.tinypic.com/flvyv4.jpg
http://i45.tinypic.com/jindba.jpg

[wacko2]

(g6civcx) i puttin wide quarter because i got hit from the other side and cost me to much fix it so i want cover the damage

[omgRWDgoodness!]

hey i have s13 coupe want put wide quarter panel 30mm, do i have do somethin to the rear like cute the quarter panel if im goin 30 mmm, been look online see any has anyone done the rear, need help with it,

I don't think you'd need to make the quarter panels cute if you want to put wide ones on. They're just going to be covered anyway :angel:

[handinpants]

find a mitsu starion in the junk yard, cut their quarter panels and weld then sand and smooth

[lazysk8er2]

rnt u supposed to flare out tabs from the body for the kit to have some reinforcement

i cant see any of the pics

[wacko2]

http://img710.imageshack.us/img710/1331/0312001736a.jpg
here where i got hit behind and did this to the right side quarter panel

[redjinjo_d1]

thats not too bad. u should have seen mine. my wife parked in a wierd spot and some old guy backed into it didnt have insurance yet kuz the car was sitting in my garage for the sr swap. so yeah life sucked. r u going to go with wider wheels and tires.

[g6civcx]

Agreed. I did a writeup on what to cut years ago, I'm sure you can find it by searching my username with cut and quarterpanel.

In one of your posts you said some body shops use 3M tape. What 3M tape is this?

I'm looking to install mine. Wonder if there's an easier way than drilling and rivets.

[g6civcx]

Mine BTW. Coils set on stock height for reference with stock car.

http://www.nguyenconsult.com/zilvia/Fender/FenderCut1.JPG

Compare with stock.

http://www.nguyenconsult.com/zilvia/Fender/StockFender.JPG

I put seam sealer over the seam welds for an airtight seal.

http://www.nguyenconsult.com/zilvia/Fender/FenderCut2.JPG

[aznpoopy]

http://img710.imageshack.us/img710/1331/0312001736a.jpg
here where i got hit behind and did this to the right side quarter panel

are you kidding me?

DONT cut that shit up or cover it up with a overfender.

DO go inside the car, remove the interior trim, push that shit out with your hand. done in 5 minutes.

[tunersedge]

are you kidding me?

DONT cut that shit up or cover it up with a overfender.

DO go inside the car, remove the interior trim, push that shit out with your hand. done in 5 minutes.

exactly, that dent is in a location where you could just push it out literally from the inside.

[wacko2]

alright then thanks for the help