importdude
05-13-2010, 12:19 AM
Ok Here is the problem. New exedy Oem replacement clutch, new Tob, pilot bearing
the problem is when i try to adjust the pedal as per fsm specs (7.5 inch from floor to pedal pad)
I will need to extend the rod MAX out
Engagement is All the way to the top
When i adjust the rod to lower the engagement, it has major freeplay(unless i adjust freeplay stopper)
Which then makes the pedal ~4 inches from the floor
The thing is i ordered a new Nabco clutch master, and the rod was LONGer than the factory one i pulled out. So i tossed the rod and used my oe rod. Im thinking i need the longer rod now??
if anyone has their Master cylinder off can you measure the rod for me!
thxn
Car drives/shifts fine. Its just when the pedal high is at spec 7.5 inches
the rod is maxed out. The engagement is WAY WAY high
the problem is when i try to adjust the pedal as per fsm specs (7.5 inch from floor to pedal pad)
I will need to extend the rod MAX out
Engagement is All the way to the top
When i adjust the rod to lower the engagement, it has major freeplay(unless i adjust freeplay stopper)
Which then makes the pedal ~4 inches from the floor
The thing is i ordered a new Nabco clutch master, and the rod was LONGer than the factory one i pulled out. So i tossed the rod and used my oe rod. Im thinking i need the longer rod now??
if anyone has their Master cylinder off can you measure the rod for me!
thxn
Car drives/shifts fine. Its just when the pedal high is at spec 7.5 inches
the rod is maxed out. The engagement is WAY WAY high