what s14 driveshaft is this?

[r20crazy]

** I can get additional pics if needed, and measure anything needed within a few days**

Background: did a manual conversion swap in a 95 s14. bought 2 driveshafts one complete unit, the other a front piece outa a 95 non abs s14. the front piece bolts perfectly and works fine for the car, but the complete unit ( referenced as 'W' from now on)is VISUALLY different and has a different bolt pattern where they join. so the pieces are NOT interchangable. the one in the car is a s14 non abs auto rear half and the manual 95 non abs front piece and where the 2 parts connect is 12mm bolts.

the COMPLETE unit 'W' bolts together with 14mm bolts.

Question: what is the complete driveshaft 'W' out of? if its just simple measuring I can redo if cant figure out from the pics.

**note: the splash guard has been removed from 'W', the one in question, it was there originally but was bent to hell**

so in this pic the one on top is the 95 non-abs front piece in the car currently, 'w' is shown on the bottom with the blue tape
http://i3.photobucket.com/albums/y81/r20crazy/240%20part/driveshaft_hlp002.jpg

here you can see the very different bolt pattern, and the one on the left is in the car and bolts to the auto non-abs rear half that the car had, 'w' on the right.
http://i3.photobucket.com/albums/y81/r20crazy/240%20part/driveshaft_hlp004.jpg

rear half of 'W' in question that ONLY bolts to the front half 'w' on the right in the pic above.
http://i3.photobucket.com/albums/y81/r20crazy/240%20part/driveshaft_hlp005.jpg

length of the rear half of shaft 'W' above (idk if it was measured correctly)
http://i3.photobucket.com/albums/y81/r20crazy/240%20part/driveshaft_hlp006.jpg

i figured just the bolt pattern will tell alot about 'W', but maybe I'm wrong. help pls, thanks in advance

[r20crazy]

so I guess noone knows or noone gives a chit hu?

[ManoNegra]

*crickets* *crickets*
Robert PM Russ, ProjectRDM, don't know of anyone else that would know

[r20crazy]

thanks Juan. I'll see you at the shop this wknd, and I'll bring it by if I can get ahold of eugene.

[r20crazy]

ok, so how does one measure the front piece?

for the front half if i measure u joint center to center I get 415mm or 16.33".

if i measure inputshaft u joint to inner flange i get 447mm or 17.57".

overall length input tip to flange is 605mm or ~23.8".

either of these 2 measurements is about 0.25" off what the fsm says for AT or MT.

edit: and I'm still not understanding the 14mm bolts stated above.

[r20crazy]

deleted this posting due to incorrect info on my part