drift freaq
04-27-2010, 07:38 PM
I have sold these over the years. Lots of track time with people running these mounts. Lots of daily drivers. For KA/SR or CA.
They are Custom Urethane Engine mounts I have made.
These are high durometer polyurethane engine mounts. The mount bolts do not run straight through the Urethane .
This is done so as to prevent vibrational transfer that you would get with straight through side to side stud.
On top of that these are not tubes of Polyurethane! They are a molded setup using Polyurethane you cannot buy at Home Depot aka the industrial window caulking stuff which is inferior!
These can lower you engine up to 3/4 of inch depending on how you position them.
The maximum amount is achieved when the offset bolts are placed on the outside with the centered bolts on top.
here is a tech review of them as well. http://zilvia.net/f/tech-talk/317539-product-review-drift-freaqs-engine-mouts.html#post3416846
It is highly recommended that you use the factory heat shield from your stock mounts on the exhaust side of the engine, especially if you are running a Turbo!
These are $120 a pair with $15 shipping so thats $135 shipped!
http://i705.photobucket.com/albums/ww52/driftfreaq/IMG_0662.jpg
They are Custom Urethane Engine mounts I have made.
These are high durometer polyurethane engine mounts. The mount bolts do not run straight through the Urethane .
This is done so as to prevent vibrational transfer that you would get with straight through side to side stud.
On top of that these are not tubes of Polyurethane! They are a molded setup using Polyurethane you cannot buy at Home Depot aka the industrial window caulking stuff which is inferior!
These can lower you engine up to 3/4 of inch depending on how you position them.
The maximum amount is achieved when the offset bolts are placed on the outside with the centered bolts on top.
here is a tech review of them as well. http://zilvia.net/f/tech-talk/317539-product-review-drift-freaqs-engine-mouts.html#post3416846
It is highly recommended that you use the factory heat shield from your stock mounts on the exhaust side of the engine, especially if you are running a Turbo!
These are $120 a pair with $15 shipping so thats $135 shipped!
http://i705.photobucket.com/albums/ww52/driftfreaq/IMG_0662.jpg