Electromotive Tec3 (complete minus trigger wheel)

[Josh]

1500 Shipped OBO

For sale is a used Electromotive Tec3 ECU. The unit currently works with WinTec3 but is upgradeable to WinTec4. It is in perfect working condition except for the IAC control but, if you are even looking at this you most likely do not need it because you are putting it into something too awesome! However, if you require such things the control can be replaced by electromotive for $125.00.

Moving on...

The following is included.

1. Tec3 ECU
2. New GM CLT sensor with pigtail
3. New GM IAT sensor with pigtail
4. New 1/2in MAG sensor with pigtail
5. Used GM 3 BAR MAP sensor with pigtail
6. Knock sensor pigtail
7. Injector harness (may or may not work for your application)
8. Tec3 wiring harness (plenty of length; shielded wire is full length)
9. 4 New LS7 coilpacks with pigtails
10. 6 used high resistance plug wires (may or may not work for your application)
11. Serial cable

This is EVERYTHING you need to run Tec3 in your 4, 6, 8 or Triangle motor. The only thing you will need is a trigger wheel which can be purchased from electromotive or on ebay (you will need a 60-2 trigger wheel).

If you have any questions please do not hesitate to ask.

I WILL SHIP WORLDWIDE
I WILL SHIP TO FPO/APO

http://www.ziptied.com/Coppermine/albums/userpics/11182/tec3.jpg
http://www.ziptied.com/Coppermine/albums/userpics/11182/IMG00064-20100422-1101.jpg
http://www.ziptied.com/Coppermine/albums/userpics/11182/IMG00065-20100422-1101.jpg
http://www.ziptied.com/Coppermine/albums/userpics/11182/IMG00066-20100422-1101.jpg
http://www.ziptied.com/Coppermine/albums/userpics/11182/coils.JPG

[JerDani]

Josh,
Do you still have the Electromotive Tec3r? Please email your response to: [email protected]

Thanks!
Jerome