need -an fitting size if available

[240Zfunahollic]

Does anyone have the size of the flare fitting that goes into the z32 caliper on conversion lines? I have a set of lines with one fitting stripped and just need to find one. Guess i learned the hard way about over torquing the fitting :(

[240Zfunahollic]

bump anyone got an answer?

[Om1kron]

how big are the lines? I'm pretty sure this is super easy to figure out.

http://zilvia.net/f/tech-talk/53356-z32-conversion-brake-line-question.html

especially if you searched.

and then googling a/n fitting size chart.

http://www.gre6.com/ansize

and viola. you should have your answer.

from that point forward if those few things are too hard to put together.

the answer is -3.

[240Zfunahollic]

didnt know if there were any differences in like the female side of a flare fitting etc or anything like that. Thanks for the help

[timlush]

M10x1.0 IIRC

[rican_nick]

here ya go dude.

Pegasus - Male 10 x 1.0mm Metric Concave Seat to 3AN Male, Steel (http://www.pegasusautoracing.com/productdetails.asp?RecID=6953)

[rican_nick]

PS call me tomorrow Cameron I think i have a couple in my pile of -an stuff.