Accidently took new fan clutch apart

[s13pignose]

I just got a clutch fan and was getting ready to transfer the plastic fan over to it off the old clutch. Keep in mind the factory clutch is one piece. Well with that in mind i was assuming the bolts on the new clutch were just new hardware included for attaching the fan with. Well I find out different when the lower half falls off on to the table. Small amount of the fluid leaked out from the center There looks to be a good amount left, but then again I don't build fan clutch's for a living. Only thing I could think to do was clean the gasket off inside and put back together. Since there where bolt holes I tightened down in cross pattern like you would a 4 lug wheel to hopefully ensure proper seal.

Question is should I be okay. It still has the same drag as it did out the plastic when rotating it.

Appreciate any info