1st GEN APEXi S-AFC... RARE

[TheWayItGoes909]

For Sale 1st gen Apexi S-AFC Selling AS IS Never Installed.

(1st Gen) complete with wire harness. Basically what the S-AFC does is alter the voltage the ECU receives from the MAF/MAP sensor. This causes the air/fuel mixture to either go leaner (-) or richer (+).You can adjust in increments of 2%.You can fine-tune the mixture at different RPM points (800rpm, 2400rpm, 4000rpm, 5600rpm, 7200rpm).

Please consult a professional for installation.

Size: 12cm x 13cm, *1 inch = 25.4 mm = 2.54 cm.


BUY BUY BUY

http://img267.imageshack.us/img267/9288/dsc04902.jpg (http://img267.imageshack.us/i/dsc04902.jpg/)

http://img704.imageshack.us/img704/508/dsc04907y.jpg (http://img704.imageshack.us/i/dsc04907y.jpg/)

http://img408.imageshack.us/img408/1594/dsc04909j.jpg (http://img408.imageshack.us/i/dsc04909j.jpg/)

http://img708.imageshack.us/img708/5196/dsc04914g.jpg (http://img708.imageshack.us/i/dsc04914g.jpg/)

http://img59.imageshack.us/img59/2094/dsc04904e.jpg (http://img59.imageshack.us/i/dsc04904e.jpg/)

http://img714.imageshack.us/img714/426/dsc04905k.jpg (http://img714.imageshack.us/i/dsc04905k.jpg/)




$120 Shipped + Paypal Fees

Local's PM for price

[TheWayItGoes909]

HOW TO SET FOR SR20DET (taken from FreshAlloy)
Set the switches on the back to
uudddudu
(u = up, d=down)
If you have a stock SR MAF set the vehicle to 6 on the setting wheel.
If you have a z32 MAF(and ECU tuned for a z32 MAF) set it to 2
AFC wires:
Red -- connect to power source
BLK-- connect to gnd (prefferablt the MAF gnd)
Green -- tap into RPM wire
Yellow to ECU (cut MAF signal wire)
White from MAF (cut MAF signal wire)
Blue -- no use
http://img408.imageshack.us/img408/1594/dsc04909j.jpg (http://img408.imageshack.us/i/dsc04909j.jpg/)

[TheWayItGoes909]

MOUNTS NICELY

http://img717.imageshack.us/img717/1824/afc1mounted.jpg (http://img717.imageshack.us/i/afc1mounted.jpg/)