Rittmeister
03-29-2010, 09:07 PM
As title states. I have a number of things that GC supplied to me with my kit, which I did not use, since I used Vorshlag hats at all four corners. This kit was for an S13 240SX and most of these parts were from the rear of that car, but will work for 2.5" ID springs on other applications.
I'll let the pictures do most of the talking. What's here are two GC upper spring perches for 2.5" ID springs (with the giant washers), and two of the upper insulator things, two of the big rings with the flat spot.
Also: a few of the rubber O-rings. A number of steel spacers of various sizes, that came with the Tein upper plates I used. A number of hat bushings, some steel and some bronze, again used to mate the struts with the Tein plates. A bag of the half-height nuts that work so well with the 86xx inserts (use two to jam it tight at the top).
A lot of the bits and pieces came from McMaster-Carr; I had a tendency to order extras since they were cheap. Now that the car's gone I figure someone can use these better than I, even if I use GC stuff on a future project.
http://i25.photobucket.com/albums/c88/kwstine1/IMG_2910-1.jpg
http://i25.photobucket.com/albums/c88/kwstine1/IMG_2911.jpg
http://i25.photobucket.com/albums/c88/kwstine1/IMG_2912.jpg
I'm not sure if these parts are available separately from GC any more, so I'm not really sure what to ask. How about $100 shipped OBO for all of it? Not really willing to split things up. PM if interested.
I'll let the pictures do most of the talking. What's here are two GC upper spring perches for 2.5" ID springs (with the giant washers), and two of the upper insulator things, two of the big rings with the flat spot.
Also: a few of the rubber O-rings. A number of steel spacers of various sizes, that came with the Tein upper plates I used. A number of hat bushings, some steel and some bronze, again used to mate the struts with the Tein plates. A bag of the half-height nuts that work so well with the 86xx inserts (use two to jam it tight at the top).
A lot of the bits and pieces came from McMaster-Carr; I had a tendency to order extras since they were cheap. Now that the car's gone I figure someone can use these better than I, even if I use GC stuff on a future project.
http://i25.photobucket.com/albums/c88/kwstine1/IMG_2910-1.jpg
http://i25.photobucket.com/albums/c88/kwstine1/IMG_2911.jpg
http://i25.photobucket.com/albums/c88/kwstine1/IMG_2912.jpg
I'm not sure if these parts are available separately from GC any more, so I'm not really sure what to ask. How about $100 shipped OBO for all of it? Not really willing to split things up. PM if interested.