z32 master cylinder fitting problems

[darkdrifft]

i am currently doing the z brake swap for my s14. i have removed the fitting out of my s14 master cylinder, but i am having problems putting it in to the z32 one. it seems way to tight, im afraid if i hammer it in i will acutally damage the fitting opening for the fluid. anybody have any suggestions or run into this problem? thanks for your time

[KiLLeR2001]

i am currently doing the z brake swap for my s14. i have removed the fitting out of my s14 master cylinder, but i am having problems putting it in to the z32 one. it seems way to tight, im afraid if i hammer it in i will acutally damage the fitting opening for the fluid. anybody have any suggestions or run into this problem? thanks for your time

The Definitive 300ZX Brake Swap! (http://www.importnut.net/300zxbrakeswap.htm#MC)

You may need to use sand paper to grind down the fitting to make it fit.

[MrMcgarrett]

Which Z32 bmc do you have?
The fitting for the 1" bmc is thinner then the one needed for the 1 1/16".