S14_Kouki
03-02-2010, 02:28 PM
So im going to try and sell my car. Little background I bought this car 5 or 6 years ago with the swap and acouple bolt ons. From that point on I have put a bunch of time and money into this car and it is my pride and joy. Iv been daily driving it ever since I bought it. Iv never had one single prob with this car NOT ONE. Reason for putting it up I would like to see what I can get for it. Iv been checking out e36 bmw's and well I would like to own one and build the hell out of it lol. Im in no rush to sell the car at all. Ill start off the biding at $11,000 and we can go from there. Im open to most any trades.
Quick over view:
Zenki 1996 non SE But I have ALL the SE stuff installed.
Dont know how many miles on chassis prob around 160000 and around 3000 on freshly re-built engine.
No a/c
No heat
Power Steering just needs the little bolt to the tensioner.
STRAIGHT FRAME
NEVER IN A ACCIDENT
Car just needs a paint job and its perfect.
Engine:
S15 sr20det
( Bold means everything was installed NEW around 3000 miles ago)
ACL main bearings
ACL rod bearings
ACL thrust washers
ARP headstuds
Apex headgasket
OEM rings
Balanced crank
Block and head both hot tanked
PDM 262 268 cams
BC springs
BC retainers
OEM oil pump
EVERY gasket and seal NEW
Peak Perfomance thermal intake gasket
OEM Valve seals
Mild port and polish
Must casting marks in head are ground down
DBfab Exhaust manifold
DBfab turbo elbow
Evo 9 turbo
Tial Q 50mm BOV
Peak preformance magnetic oil drain plug
stainless turbo lines
Apexi intake
Z32 MAF
Apexi exhaust
Trust downpipe
Greddy Rocker arm stoppers
Kazama motor mounts
Nismo tranny mount
Nismo FPR adapter
Aero FPR
Tomei 740 injectors
Walbro fuel pump
Electronics:
Apex power fc and commander
VIPHID's
PLX wideband
Greddy boost guage
Greddy turbo timer
Suspension / Wheels / Breaks / Drivetrain :
Stance GR+ coilovers
Nismo power brace
Tein tie rods and tie rod ends
Nismo tension rods
Adjustable Rear upper controller arms
Stance camber plates
DBfab rollcage (fully welded in)
Z32 front and rear breaks
OEM brake pads
Stainless brake lines
New front wheel bearings
DBfad brake sheild
MB weapon rims
Spec clutch
Stainless clutch line
KA tranny
DBfad brake sheild
s15 diff
Cooling:
V-mount set-up done by DBfab
Koyo radiator
DTM intercooler
Trust oil cooler
Moroso inline radiator fill
Moroso radiator cap
Stainless steel radiator lines
Other Stuff:
Recaro pole postion
RJS harness's
Nardi sport rally 350mm suede
Nismo "dildo" shift knob
Flocked dash
Extra Stuff:
S15 rear sub frame
S15 axle's
B-wave body kit
http://i58.photobucket.com/albums/g269/pandadrifter/DSC_0101.jpg
http://i58.photobucket.com/albums/g269/pandadrifter/IMG_0685.jpg
http://i58.photobucket.com/albums/g269/pandadrifter/104_0150.jpg
http://i58.photobucket.com/albums/g269/pandadrifter/104_0147.jpg
http://i58.photobucket.com/albums/g269/pandadrifter/104_0140.jpg
http://i58.photobucket.com/albums/g269/pandadrifter/104_0142.jpg
http://i58.photobucket.com/albums/g269/pandadrifter/104_0143.jpg
http://i58.photobucket.com/albums/g269/pandadrifter/104_0146.jpg
These pics r before v-mount.
http://i58.photobucket.com/albums/g269/pandadrifter/DSC04141-1.jpg
http://i58.photobucket.com/albums/g269/pandadrifter/greeeee-1.jpg
B-wave bumper CAR HAS BLACK HOOD
http://i58.photobucket.com/albums/g269/pandadrifter/bwave.jpg
Also has black quarter panel.
http://i58.photobucket.com/albums/g269/pandadrifter/DSC_0064.jpg
Quick over view:
Zenki 1996 non SE But I have ALL the SE stuff installed.
Dont know how many miles on chassis prob around 160000 and around 3000 on freshly re-built engine.
No a/c
No heat
Power Steering just needs the little bolt to the tensioner.
STRAIGHT FRAME
NEVER IN A ACCIDENT
Car just needs a paint job and its perfect.
Engine:
S15 sr20det
( Bold means everything was installed NEW around 3000 miles ago)
ACL main bearings
ACL rod bearings
ACL thrust washers
ARP headstuds
Apex headgasket
OEM rings
Balanced crank
Block and head both hot tanked
PDM 262 268 cams
BC springs
BC retainers
OEM oil pump
EVERY gasket and seal NEW
Peak Perfomance thermal intake gasket
OEM Valve seals
Mild port and polish
Must casting marks in head are ground down
DBfab Exhaust manifold
DBfab turbo elbow
Evo 9 turbo
Tial Q 50mm BOV
Peak preformance magnetic oil drain plug
stainless turbo lines
Apexi intake
Z32 MAF
Apexi exhaust
Trust downpipe
Greddy Rocker arm stoppers
Kazama motor mounts
Nismo tranny mount
Nismo FPR adapter
Aero FPR
Tomei 740 injectors
Walbro fuel pump
Electronics:
Apex power fc and commander
VIPHID's
PLX wideband
Greddy boost guage
Greddy turbo timer
Suspension / Wheels / Breaks / Drivetrain :
Stance GR+ coilovers
Nismo power brace
Tein tie rods and tie rod ends
Nismo tension rods
Adjustable Rear upper controller arms
Stance camber plates
DBfab rollcage (fully welded in)
Z32 front and rear breaks
OEM brake pads
Stainless brake lines
New front wheel bearings
DBfad brake sheild
MB weapon rims
Spec clutch
Stainless clutch line
KA tranny
DBfad brake sheild
s15 diff
Cooling:
V-mount set-up done by DBfab
Koyo radiator
DTM intercooler
Trust oil cooler
Moroso inline radiator fill
Moroso radiator cap
Stainless steel radiator lines
Other Stuff:
Recaro pole postion
RJS harness's
Nardi sport rally 350mm suede
Nismo "dildo" shift knob
Flocked dash
Extra Stuff:
S15 rear sub frame
S15 axle's
B-wave body kit
http://i58.photobucket.com/albums/g269/pandadrifter/DSC_0101.jpg
http://i58.photobucket.com/albums/g269/pandadrifter/IMG_0685.jpg
http://i58.photobucket.com/albums/g269/pandadrifter/104_0150.jpg
http://i58.photobucket.com/albums/g269/pandadrifter/104_0147.jpg
http://i58.photobucket.com/albums/g269/pandadrifter/104_0140.jpg
http://i58.photobucket.com/albums/g269/pandadrifter/104_0142.jpg
http://i58.photobucket.com/albums/g269/pandadrifter/104_0143.jpg
http://i58.photobucket.com/albums/g269/pandadrifter/104_0146.jpg
These pics r before v-mount.
http://i58.photobucket.com/albums/g269/pandadrifter/DSC04141-1.jpg
http://i58.photobucket.com/albums/g269/pandadrifter/greeeee-1.jpg
B-wave bumper CAR HAS BLACK HOOD
http://i58.photobucket.com/albums/g269/pandadrifter/bwave.jpg
Also has black quarter panel.
http://i58.photobucket.com/albums/g269/pandadrifter/DSC_0064.jpg