gsracer
02-27-2010, 01:04 PM
Well heres the info
All parts are new
Master
hardline
stainless soft line
slave
When i do a wide open throttle pull in 4th gear and try to shift into 5th the pedal goes soft, i pump it back up and it works fine again, almost as if i was boiling it, problem is the whole line is wrapped in heat shielding. It will go soft i pump it three or four times and it goes back to normal..
Any ideas.
All parts are new
Master
hardline
stainless soft line
slave
When i do a wide open throttle pull in 4th gear and try to shift into 5th the pedal goes soft, i pump it back up and it works fine again, almost as if i was boiling it, problem is the whole line is wrapped in heat shielding. It will go soft i pump it three or four times and it goes back to normal..
Any ideas.