PDA

View Full Version : GA Sr t25 F/S


kikcaffine
01-28-2010, 06:28 AM
Selling the t25 I pulled from my sr. Im only selling it because I went to a larger turbine. It will come with the intake elbow, exhaust elbow, wg, and the little 3 bolt thing on the top where the charge pipe connects. There is 0 shaft play, the intake side is bone dry. Does not smoke at idle or under boost or no time in between. There is the most minute amount of shaft play (normal for a journal bearing I guess). Looking for $140 dollars for it. Its on the steep side I know, but its not fucked up. Plenty of people can vouch on this site that I've sold stuff to that I wont sell you shit. If anyone needs any of the number on that little plate read off to them LMK.
http://i296.photobucket.com/albums/mm162/kikcaffine/SAM_0152.jpg
http://i296.photobucket.com/albums/mm162/kikcaffine/SAM_0153.jpg
http://i296.photobucket.com/albums/mm162/kikcaffine/SAM_0154.jpg
http://i296.photobucket.com/albums/mm162/kikcaffine/SAM_0155.jpg
http://i296.photobucket.com/albums/mm162/kikcaffine/SAM_0156.jpg
http://i296.photobucket.com/albums/mm162/kikcaffine/SAM_0157.jpg
http://i296.photobucket.com/albums/mm162/kikcaffine/SAM_0158.jpg

http://i296.photobucket.com/albums/mm162/kikcaffine/SAM_0160.jpg
http://i296.photobucket.com/albums/mm162/kikcaffine/SAM_0161.jpg
http://i296.photobucket.com/albums/mm162/kikcaffine/SAM_0162.jpg
http://i296.photobucket.com/albums/mm162/kikcaffine/SAM_0163.jpg

Payne219- I'd prefer not to part it out right yet.

payne219
01-28-2010, 09:31 AM
willing to part the elbows out? if so how much shipped to 91901?