PDA

View Full Version : PA Stock RB20DET Parts


dtowngoalie
01-22-2010, 01:08 PM
Looking to clear out all my RB20 stuff since I've sold the car. I'm located in York, PA and anything can be picked up or shipping on your dime. Email me at [email protected] for picsor questions.
All parts came off an RB20:
Uncut engine harness - SOLD
Code 22 ECU - 100
Igniter - 40
CAS - SOLD
MAF - SOLD
6 coil packs with complete harness and brackets(little cracked up) - SOLD
Transmission(Local pickup only) - 150
Both cams and gears - 25 ea
Exhaust manifold - 50
Turbo elbow - 25
Turbo elbow with stock downpipe attatched - 50
Stock RB20 turbo -SOLD
Bare block(local pickup only) - 75
Bottom half of intake manifold - SOLD
Brackets that connect block to bottom of trans. - 20
CAS Bracket - 20
Clutch fan - 25
Fuel rail w/ injectors and regulator - 50

thedr1ftkid
01-22-2010, 07:24 PM
Do you have a powersteering pump?

eklips3
01-23-2010, 12:17 AM
pm sent !!

boske
01-23-2010, 12:28 PM
Hey I sent you a PM about a flywheel, let me know I can pick it up if you have one.

rb20240sx
01-23-2010, 08:48 PM
dibs on cas if you still have it youv been messaged

B-_-RAD
01-24-2010, 02:05 PM
Dibbs on harness! pm sent.

dtowngoalie
01-28-2010, 09:13 PM
Hey I sent you a PM about a flywheel, let me know I can pick it up if you have one.

DL on the flywheel is that the one that came on my new longblock... the crank bolt pattern is the same, but my "rb20" clutch didnt bolt onto the new flywheel, so my old flywheel got bolted to the motor in the car and i have the unknown flywheel w/ clutch in my garage. clutch is a tiny bit smaller on this flywheel. You can check it out if you're interested.

louie661
01-28-2010, 09:39 PM
I'm interested in the maf and stock turbo. I can paypal tomorrow. PM sent

xDRFTurR1D3x
01-28-2010, 10:45 PM
wastegate available? pm me please!

dtowngoalie
01-31-2010, 09:42 PM
Parts list updated

Dirty Dee
02-01-2010, 12:27 AM
would you part with a water fitting on the block of the RB?

It is right by the thermostat:




http://i110.photobucket.com/albums/n103/cg350z/240sx/IDthis1.jpg

http://i110.photobucket.com/albums/n103/cg350z/240sx/IDthis2.jpg

dtowngoalie
02-02-2010, 07:17 AM
would you part with a water fitting on the block of the RB?

It is right by the thermostat:




http://i110.photobucket.com/albums/n103/cg350z/240sx/IDthis1.jpg

http://i110.photobucket.com/albums/n103/cg350z/240sx/IDthis2.jpg
Should still be on my block in the barn, I'll check, yours as long as I can get it off :eek3d:

Dirty Dee
02-03-2010, 05:25 AM
awesome.


let me know

thursdaymike
02-03-2010, 08:28 AM
do u still have the maf, i emailed u from nico.

PacificDrift_Nick
03-16-2010, 01:20 AM
Ecu shipped 90039?