gsracer
06-03-2003, 11:20 AM
ok guys i had a brain storm, on the donor s14 that i have that i am pulling the stick tranny out of, i have the complete manual tranmission harness, the one that goes up to the alternator, and to the bottom of the fuse box, so i decide that im gonna use that harness out of the stick shift instead of adapting my auto harness, however here is the trick, all of the connectors are the same, like the seven wire one that goes in to the car , the alternator, and engine sensors etc, except there is only one difference....... the two connector that go to the bottom of my fuse box (not on the 4 on the side) are somewhat different. on my auto fuse box the big connector is the same except that it has 4 wires and the maual harness has 8, and the smaller 2 wire connector is different becuase the manual harness has three and the connector is different. (again these are not the ones that are on the side but two that are on the bottom).
Has anyone done this before or can the give me the me the pinouts for those two connectors or the fuse box or at least tell me what the wires are for , any help is appreciated. please this is the last thing holding me up. I want to go for the factory look.
Has anyone done this before or can the give me the me the pinouts for those two connectors or the fuse box or at least tell me what the wires are for , any help is appreciated. please this is the last thing holding me up. I want to go for the factory look.