View Full Version : 300ZX Turbo Gears in a 240SX
Jim96SC2
05-30-2003, 03:28 PM
Anyone know if the rear ring and pinion final gear is compatible from the 300ZX R230? to the 240SX R200? I want the lower gear ratio for my car but don't want to spend $500 from courtesy nissan.
AKADriver
05-30-2003, 03:53 PM
No.
The # after the R indicates the diameter of the ring gear in mm. The 230mm ring gear won't fit.
I'd look into grabbing the ring and pinion from a Z31 Turbo's R200. I think that ratio is 3.545:1.
Jim96SC2
05-30-2003, 06:51 PM
thanks dude. I think that 3.5 is a bit low
cnichols
07-18-2005, 12:04 PM
Back from the deadly...but I need something around a 3.5 final drive ratio and can't find any solid info on whether or not the R&P from a Z31 will indeed work.
Can anyone confirm this for certain?
kandyflip445
07-18-2005, 01:18 PM
Yes. Make sure you check how the gears mesh and reshim if needed (which it most likely will). Inspect all bearings and such also.
SirWarrior
07-18-2005, 03:25 PM
WTF? you guys tring to join the 200MPH club???
DeatschWerks
07-18-2005, 03:41 PM
given the mods in your sig... are you sure you want a 3.5X final drive? It will just make your car accellerate slower.
boosteds13
07-18-2005, 05:18 PM
WTF? you guys tring to join the 200MPH club???
LOL, that's what I was thinking.... taking it out to the salt flats for a new land speed record?
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.