philstar
12-12-2009, 12:59 AM
6k FIRM, parts can be removed to lower price.
Car is a super clean Oregon car which was brought here over summer. Its a Kouki model. NO RUST, underbody is super super clean. typical dings n dents. Clean Title. I have an entire folder of papers for pretty much the entire cars life, maintenance, etc.
This car is pretty refreshed and feels awesome. Parts can be removed to lower price. Make me an offer. I dont really need to get rid of it but some extra money would be nice right now.
Car drives great, drifts great, handles great, brakes great. NO JOY RIDES unless you have cash in hand, but I will take you for a drive.
Engine/Transmission:
- 4age, 230K-ish
-OEM Timing belt and water pump performed by toyota dealer recently
-NEW OEM toyota battery
-HKS Hi-Power Exhaust
-T3 testpipe
-New Toyota battery from dealer
-Cusco engine and transmission mounts
-OEM shifter rebuild kit
-OEM clutch type LSD, locks great
Suspension/brakes:
-Greddy Type-S Fully Adjustable Coilovers with Camber Plates
-CUSCO Front Tower Bar
-Energy Suspension polyurethane bushing kit
-Project Mu B-Force Brake Pads
-T3 RCA's
Wheels:
-14x8 -12 SSR Mesh (2) 195/60/14
-14x7 -9 Konig Rewinds (2) 185/60/14
Exterior:
-Rattlecanned Flat Almond
-front fenders have been rolled and pulled, rear fenders have been rolled
-JDM Zenki front bumper
-JDM Zenki rear bumper
-JDM Zenki front bumper brackets
-JDM Zenki rear bumper brackets
-JDM Zenki front lip
-JDM Zenki grill
-JDM Kouki eyelids
-JDM Kouki fender lights
-JDM OEM Trueno emblem
-Origin Lab trunk spoiler
Interior:
-Black full interior, no cracks in dash
-BOSS steering wheel HUB
-Works Bell 25mm steering wheel spacer
-Personal 300mm Neo Grinta steering wheel
-Buddyclub seat rails
-Bride Zeta I bucket seat (also have stock seat)
-NRG 4-point harness
Other parts not installed:
-Megan panhard bar
-Cusco rear strut bar
-JDM OEM steering wheel
Bad:
-several wheel studs need to be replaced (because I used OEM lugs with aftermarket wheels), I can replace before purchase.
-small oil leak (from valve cover gasket and distributor o-ring), I have new valve cover gaskets not installed yet.
-Front window top molding not installed (I have new part)
PM me or ideally e-mail me at [email protected] I can get detailed pictures if requested.
http://i35.tinypic.com/6c6f.jpg
http://i33.tinypic.com/2ziuhli.jpg
http://i36.tinypic.com/p7p5v.jpg
Car is a super clean Oregon car which was brought here over summer. Its a Kouki model. NO RUST, underbody is super super clean. typical dings n dents. Clean Title. I have an entire folder of papers for pretty much the entire cars life, maintenance, etc.
This car is pretty refreshed and feels awesome. Parts can be removed to lower price. Make me an offer. I dont really need to get rid of it but some extra money would be nice right now.
Car drives great, drifts great, handles great, brakes great. NO JOY RIDES unless you have cash in hand, but I will take you for a drive.
Engine/Transmission:
- 4age, 230K-ish
-OEM Timing belt and water pump performed by toyota dealer recently
-NEW OEM toyota battery
-HKS Hi-Power Exhaust
-T3 testpipe
-New Toyota battery from dealer
-Cusco engine and transmission mounts
-OEM shifter rebuild kit
-OEM clutch type LSD, locks great
Suspension/brakes:
-Greddy Type-S Fully Adjustable Coilovers with Camber Plates
-CUSCO Front Tower Bar
-Energy Suspension polyurethane bushing kit
-Project Mu B-Force Brake Pads
-T3 RCA's
Wheels:
-14x8 -12 SSR Mesh (2) 195/60/14
-14x7 -9 Konig Rewinds (2) 185/60/14
Exterior:
-Rattlecanned Flat Almond
-front fenders have been rolled and pulled, rear fenders have been rolled
-JDM Zenki front bumper
-JDM Zenki rear bumper
-JDM Zenki front bumper brackets
-JDM Zenki rear bumper brackets
-JDM Zenki front lip
-JDM Zenki grill
-JDM Kouki eyelids
-JDM Kouki fender lights
-JDM OEM Trueno emblem
-Origin Lab trunk spoiler
Interior:
-Black full interior, no cracks in dash
-BOSS steering wheel HUB
-Works Bell 25mm steering wheel spacer
-Personal 300mm Neo Grinta steering wheel
-Buddyclub seat rails
-Bride Zeta I bucket seat (also have stock seat)
-NRG 4-point harness
Other parts not installed:
-Megan panhard bar
-Cusco rear strut bar
-JDM OEM steering wheel
Bad:
-several wheel studs need to be replaced (because I used OEM lugs with aftermarket wheels), I can replace before purchase.
-small oil leak (from valve cover gasket and distributor o-ring), I have new valve cover gaskets not installed yet.
-Front window top molding not installed (I have new part)
PM me or ideally e-mail me at [email protected] I can get detailed pictures if requested.
http://i35.tinypic.com/6c6f.jpg
http://i33.tinypic.com/2ziuhli.jpg
http://i36.tinypic.com/p7p5v.jpg