missinpistons
12-07-2009, 11:32 AM
EDIT:LET THE PARTOUT BEGIN!
i sold my shell so im all set to sell the drivetrain.
motor is bulletproof, has around 30k miles the previous setup made under 300hp on a conservative tune so it wasn't pushed near its limits.
GT2871R has less then 500 miles on it probably closer to 250 miles honestly... all new gaskets from the turbo to the exhaust, intake you name it
this will come with everything to drop in your car and drive it.
the motor is tuned with a power fc and commander which will be included and is tuned to 20lb and makes 333whp on a low reading dyno dynamics.
car pulls strong and hard everytime...tranny shifts smooth as butter.
i would rather not ship but will at buyers expense plus some.
please respect the amount of money i have into my setup.
$6,000 FOR EVERYTHING
$4000 FOR LONGBLOCK AND TRANNY WITH EXEDY CLUTCH/FLYWHEEL AND B&M SHORT THROW SHIFTER
HEAD
Brian Crower Springs and Retainers
Greddy Easy Cams 256/264
New Exhaust Valve Guides
New Valve Guide Seals
Polished Exhaust Ports
Polished Combustion Chambers
3 Angle Valve Job
MOTOR
CP 86.5 mm 9:1 Forged Pistons (Motor was Bored with Torque Plate)
Eagle Rods
ACL Race Bearings
Balanced Crank
New oil pump/Front Cover
New Timing Chain/Chain Guides
Greddy Oil Pan
Block and Head were skimmed/decked to ensure flatness
Apexi Metal Head Gasket 87mm stock thickness
ARP Head Studs
Nismo Motor + Tranny Mounts
INDUCTION
Garrett GT2871R .64 ar - $1100 with coolant and oil lines
Peak Performance Exhaust Manifold- $500 or $1550 with lines and turbo
Steel Braided Turbo Lines- going with turbo
Z32 MAf - $80
Apexi Intake Filter- $50
HKS BOV on Custom 2.25in Hotpipe - $200
INTAKE
Isis Intake Manifold with TB and cold pipe (cleaned up,polished)- $200(pending)
Peak Performance Intake Manifold thermal gasket/spacer-$15(pending)
COOLING
Blitz LM Front Mount Intercooler- $500
Koyo Radiator w/ fresh Blitz Radiator Cap- $200
Samco Coolant hoses- $45 (pending)
FUEL/ENGINE MANAGEMENT/BOOST CONTROL
Tomei 740cc Injectors- $SOLD
SARD FPR- $SOLD
Apexi PowerFC tuned Dent Sport Garage- $SOLD
Blitz Boost Controller - $250
EXHAUST
Isis Race Blaster Pipes- $200
Blitz Downpipe- $100
Resonated Test Pipe- $40
Greddy Turbo Outlet- $175
CLUTCH/FLYWHEEL- for sale with motor only
Exedy Stage 2 clutch
Exedy Lightweight Flywheel
B&M Short Shifter
OTHER PARTS NOT INCLUDED WITH MOTOR
Sparco EVO seat with seat rails and Crowe 4pt. Cam lock harness(seat is black and in perfect condition, no rips, stains, fading etc.- $500
Kaaz 2way LSD(oiled at every oil change)- $SOLD
MOMO steering wheel(basically brand new) - $175
http://i33.photobucket.com/albums/d64/CoreyMar4/2009-11-13162934.jpg
http://i33.photobucket.com/albums/d64/CoreyMar4/2009-12-05174257.jpg
http://i33.photobucket.com/albums/d64/CoreyMar4/2009-12-05174339.jpg
i sold my shell so im all set to sell the drivetrain.
motor is bulletproof, has around 30k miles the previous setup made under 300hp on a conservative tune so it wasn't pushed near its limits.
GT2871R has less then 500 miles on it probably closer to 250 miles honestly... all new gaskets from the turbo to the exhaust, intake you name it
this will come with everything to drop in your car and drive it.
the motor is tuned with a power fc and commander which will be included and is tuned to 20lb and makes 333whp on a low reading dyno dynamics.
car pulls strong and hard everytime...tranny shifts smooth as butter.
i would rather not ship but will at buyers expense plus some.
please respect the amount of money i have into my setup.
$6,000 FOR EVERYTHING
$4000 FOR LONGBLOCK AND TRANNY WITH EXEDY CLUTCH/FLYWHEEL AND B&M SHORT THROW SHIFTER
HEAD
Brian Crower Springs and Retainers
Greddy Easy Cams 256/264
New Exhaust Valve Guides
New Valve Guide Seals
Polished Exhaust Ports
Polished Combustion Chambers
3 Angle Valve Job
MOTOR
CP 86.5 mm 9:1 Forged Pistons (Motor was Bored with Torque Plate)
Eagle Rods
ACL Race Bearings
Balanced Crank
New oil pump/Front Cover
New Timing Chain/Chain Guides
Greddy Oil Pan
Block and Head were skimmed/decked to ensure flatness
Apexi Metal Head Gasket 87mm stock thickness
ARP Head Studs
Nismo Motor + Tranny Mounts
INDUCTION
Garrett GT2871R .64 ar - $1100 with coolant and oil lines
Peak Performance Exhaust Manifold- $500 or $1550 with lines and turbo
Steel Braided Turbo Lines- going with turbo
Z32 MAf - $80
Apexi Intake Filter- $50
HKS BOV on Custom 2.25in Hotpipe - $200
INTAKE
Isis Intake Manifold with TB and cold pipe (cleaned up,polished)- $200(pending)
Peak Performance Intake Manifold thermal gasket/spacer-$15(pending)
COOLING
Blitz LM Front Mount Intercooler- $500
Koyo Radiator w/ fresh Blitz Radiator Cap- $200
Samco Coolant hoses- $45 (pending)
FUEL/ENGINE MANAGEMENT/BOOST CONTROL
Tomei 740cc Injectors- $SOLD
SARD FPR- $SOLD
Apexi PowerFC tuned Dent Sport Garage- $SOLD
Blitz Boost Controller - $250
EXHAUST
Isis Race Blaster Pipes- $200
Blitz Downpipe- $100
Resonated Test Pipe- $40
Greddy Turbo Outlet- $175
CLUTCH/FLYWHEEL- for sale with motor only
Exedy Stage 2 clutch
Exedy Lightweight Flywheel
B&M Short Shifter
OTHER PARTS NOT INCLUDED WITH MOTOR
Sparco EVO seat with seat rails and Crowe 4pt. Cam lock harness(seat is black and in perfect condition, no rips, stains, fading etc.- $500
Kaaz 2way LSD(oiled at every oil change)- $SOLD
MOMO steering wheel(basically brand new) - $175
http://i33.photobucket.com/albums/d64/CoreyMar4/2009-11-13162934.jpg
http://i33.photobucket.com/albums/d64/CoreyMar4/2009-12-05174257.jpg
http://i33.photobucket.com/albums/d64/CoreyMar4/2009-12-05174339.jpg