Ls1 motor mounts for s13 or s14 and drive shaft

[RB26Sileighty]

I am asking $350 for the set of motor and trans mounts. These are direct bolt in mounts with fabrication of the sub frame....I am asking $500 for the Ls1 to s14 driveshaft.


http://i142.photobucket.com/albums/r94/rb26sileighty/Picture919-1.jpg

Modification to cross member...
http://i142.photobucket.com/albums/r94/rb26sileighty/Picture870.jpghttp://i142.photobucket.com/albums/r94/rb26sileighty/Picture874.jpg

[TUnity2]

who made the mounts? got pics?

[TurboGoKart]

Who made the mounts? Thanks!

[RB26Sileighty]

I made them In my shop...The use the factory rubber motor mounts on the block... I replaced factory rubber with polly mounts.....I'll see if I can take some pics of them. They don't rub or touch any part of the chassis. Hood closes nicely.

[napoleon]

you can buy the subframe, ready to go for $550 and the driveshaft for $350 from daftinnovations.

Just sayin'

[MunsonAuto]

A lot of guys complain about Daft's S13 kit not fitting properly in S14's...so I'd think this would be similar being that the pic is of a S14, leading peeps/me to think your mounts are based off S14, therefore might 'cause fitment issues with S13.
Just trying to help you out in case there's any confusion later on down the old dusty trail...aka road.

[RB26Sileighty]

I think it would be better fit in s13 then s14 since s14 chassis tunnels are a little smaller then s13....