PowerFC Boost Kit Install

[Erjay1]

I've got a late model kouki sr20det running a power fc (414AN016).
The boost control kit I have is (415A013) which is compatible with my pfc.
1. I need to know if all components are installed correctly.
2. How to wire solenoid to stock harness.
3. Can I wire directly to pins on ecu? Which ones?
Thanks
I tried following this diagram:
http://i18.photobucket.com/albums/b113/DragOnYou/IMG_1266.jpg
Solenoid is mounted here, with vaccum line to wastegate actuator.
http://i18.photobucket.com/albums/b113/DragOnYou/IMG_1290.jpg
http://i18.photobucket.com/albums/b113/DragOnYou/IMG_1300.jpg
http://i18.photobucket.com/albums/b113/DragOnYou/IMG_1299.jpg
MAP sensor is mounted here and plumbed to Nismo FPR.
http://i18.photobucket.com/albums/b113/DragOnYou/IMG_1295.jpg
http://i18.photobucket.com/albums/b113/DragOnYou/IMG_1296.jpg

I figured out that this normally plugs into the stock solenoid plug. Apparently the stock boost solenoid was removed and so was the connector.
Solenoid plug
http://i18.photobucket.com/albums/b113/DragOnYou/IMG_1302.jpg

[Sileighty_85]

You cut off the Stock Boost contoller solenoid plug and splice in the PFC boost solenoid wires the stock B/C wires, Polarity does not matter

If the harness was remeoved then you need to find the pin out on the ECU

I think you have to mount the Boost Sensor sraight up and down

[Erjay1]

Alright thanks man. I have the ecu pinouts somewhere so I'll check those in a bit.