PDA

View Full Version : idele for ka24


smkscrn00
05-10-2003, 06:25 PM
Well i cant spell the damn word but i need to know were the idele screw is on the ka24 motor in a s13

AceInHole
05-10-2003, 08:23 PM
on DOHC's, side of the intake plenum, closest to the firewall.

smkscrn00
05-11-2003, 11:30 PM
my 90 s13 is a sohc

CrazyS13
05-12-2003, 06:38 AM
The idle screw is on the intake plenum, at the rear near the firewall on the left side when looking at the engine from the front. Turn left to go down and right to go up. A good hint is look where the fuel lines go from rubber to solid after the fuel filter, it is right near there.

-John

smkscrn00
05-12-2003, 04:01 PM
what is a good idel for it right know it idels at 500 but the cars idel jumps around when it gets hot would having an upgraded fuel pump do that i got a walbro 255 on my k24 (i need a new pump and i am doing the sr swap)

CrazyS13
05-14-2003, 08:21 AM
hmm, i have a walbro on my ka24e, my fuel pressure is at 46 psi at idle (kinda high) My idle is funny sometimes, but for the most part it stays where it should. When tuning the idle, have it idle around 800-900 (i like it a hair higher than the factory 750rpm). Even with a walbro pump it should stay right around there.

-John