PDA

View Full Version : CA 1jz Engine Front Sump Pan Ready For A 240sx!!!


cfinch
09-08-2009, 04:22 PM
Alright I got this 1jz just sitting here... Need it gone!

The 1jz I have I just had the cylinder head rebuilt by Cylinder Head Technologies, brand new oem Toyota gasket set and Arp headstuds. I've already tore down the motor and resealed everything, installed new seals, cylinder head etc... It's pretty much ready to go! It has the front sump pan, jzx81 mounts, 2jz waterpump etc ready to drop in a cressida or s-chassis! I have an engine harness for the motor but no ecu... Also I have a Spec pressure plate for both the r154/w58 and a t04e turbo. All it needs is a trans, ecu, flywheel, clutch disc, bell housing, single turbo manifold, wastegate and thats about it to finish this project. Well some other misc odds and ends and bigger injectors/engine management would be good too.

Motor was running but wanted to freshen it up before I dropped it in my cressida... Ran out of money for the project and sold the car so now this needs to go. I wound up selling the trans and some odds and ends but it doesn't need much to be a complete swap again!

Asking $1,200obo

Located in Oak Hills, CA. The motor can also be picked up at my shop in Redlands, CA

http://i28.photobucket.com/albums/c239/cfinch702/P7031069.jpg
http://i28.photobucket.com/albums/c239/cfinch702/P7031070.jpg
http://i28.photobucket.com/albums/c239/cfinch702/P7031071.jpg

longdy
09-11-2009, 10:20 PM
which harness do you have? is it the soarer one? lol just wondering if you might know of a place that i could get one or even trade my jzx harness for the soarer one!..lol

THanks