drz
09-02-2009, 12:45 PM
I have this S13 Blacktop SR20DET long-block for sale, rebuilt by me at HK Racing Engines where I've worked for the last 2 years. I was originally going to use this engine for myself, but my project changed direction. This engine is completely freshened with a few upgrades. Don't take your chances on a used long-block with no history, this engine is built RIGHT. All machine work performed at HK Racing Engines including cylinder hone, line bore, head/block surfacing, rod resizing, pin-fit, ring fit, crank polishing, etc. This engine is safe to 400whp and 8000rpm all-day.
I've built many engines for Texas drifters over the years, including SRs and LS1s for Aaron Losey, Stewart Leask, Tyler Cox, and others. All of these veteran Texas drifters can vouch for my engines. No attention is spared is the building of these engines, and their performance and durability speak for themselves.
This long-block consists of:
ARP head studs
ARP rod bolts
Cometic MLS head gasket
Total Seal conventional AP rings
Polydyne coated ACL Race bearings, mains and rods
New timing chain/guides
blueprinted, shimmed oil pump
New seals/gaskets
$1600 local pickup, shipping can be arranged.
I also have an intake manifold w/ TB minus injectors I will throw in if you need it.
CAS in photo is not included but is extra if you need it
http://www.d-rog.com/4sale/sr2.jpg
http://www.d-rog.com/4sale/sr1.jpg
Engine and parts are located in west Houston, but shipping can be arranged.
Contact me by PM or by phone at 832-971-1806i
I've built many engines for Texas drifters over the years, including SRs and LS1s for Aaron Losey, Stewart Leask, Tyler Cox, and others. All of these veteran Texas drifters can vouch for my engines. No attention is spared is the building of these engines, and their performance and durability speak for themselves.
This long-block consists of:
ARP head studs
ARP rod bolts
Cometic MLS head gasket
Total Seal conventional AP rings
Polydyne coated ACL Race bearings, mains and rods
New timing chain/guides
blueprinted, shimmed oil pump
New seals/gaskets
$1600 local pickup, shipping can be arranged.
I also have an intake manifold w/ TB minus injectors I will throw in if you need it.
CAS in photo is not included but is extra if you need it
http://www.d-rog.com/4sale/sr2.jpg
http://www.d-rog.com/4sale/sr1.jpg
Engine and parts are located in west Houston, but shipping can be arranged.
Contact me by PM or by phone at 832-971-1806i