Log in

View Full Version : Motor mounts and measurements

NINJASPY
08-09-2009, 04:03 PM
anyone have measurements of the s14 engine and transmission mounts?
I want to get some polyurethane and make/patch up my mounts.

here is a seller on craigslist who has a delrin mount.

Brand new Solid motor mounts 89-02 Nissan Silvia s13 s14 s15 240sx (http://losangeles.craigslist.org/sgv/pts/1312665485.html)

opinions?
Jonnie Fraz
08-09-2009, 10:28 PM
If you want stiff mounts go with these...Kazama Motor Mounts (http://www.cimotorsports.net/motor-sport-products/kazama-auto-engine-mounts-89-02-nissan-silvia-s13s14s15.html)
Or just fill your stockers with 3M window weld $18.00 a tube...done
GSXRJJordan
08-10-2009, 04:01 AM
Vouch for "polyurethane adhesive"-filling your stock mounts. The perfect mix of stiffness and no interior rattles at idle.
Five_5Zigen_4
08-10-2009, 04:27 AM
Or just fill your stockers with 3M window weld $18.00 a tube...done


Quoted for truths. Just did this on my motor mounts because all my money was dumped into other b/s lol

Ghetto-Fabrication FTW.
singlecamslam
08-10-2009, 10:11 AM
Dont those Kazama mounts lower the engine some and you would have to lower the transmission as well?
projectRDM
08-10-2009, 11:30 AM
Dont those Kazama mounts lower the engine some and you would have to lower the transmission as well?

The driveline angle isn't that steep. Lowering one end even an inch won't effect the other end enough to matter. Plenty of people put spacers behind the transmission crossmember to increase clearance from downpipes or larger exhausts.
NINJASPY
08-10-2009, 09:05 PM
any fixes for transmission mount?

feels like all my mounts are shot...
Slip&Sliden 240
08-10-2009, 11:42 PM
The driveline angle isn't that steep. Lowering one end even an inch won't effect the other end enough to matter. Plenty of people put spacers behind the transmission crossmember to increase clearance from downpipes or larger exhausts.

I lowered my engine with my own custom mounts. Without lowering the transmission it it destroyed the drive shaft carrier bearing. So I lowered the transmission and went with a 1 piece aluminum. Sweet deal
projectRDM
08-11-2009, 08:18 AM
I lowered my engine with my own custom mounts. Without lowering the transmission it it destroyed the drive shaft carrier bearing. So I lowered the transmission and went with a 1 piece aluminum. Sweet deal

How much, a foot?