WTB: S14 USDM Kouki Sideskirt End Caps

[Driven08]

I am looking for the (2) S14 USDM Kouki Sideskirt End Caps. PM me if you have what I am looking for thanks.

[Driven08]

Still looking for these.

[nightkids14]

good luck brother. I had one side and i traced it and made an end cap from a spare piece of plastic that i cut off the back of a craftsman tool case. i will tell you how it comes out.

[nightkids14]

this is what i did.

If I did it again, I would wait to glue it before putting it on the car :duh: Cut out the end cap and fit it to the side skirt to make sure there are no gaps. I had to re-glue it because i set it in too far.

I traced out the driver side end cap and cut it out of a piece of the back of a craftsmen tool box. Any semi-thick piece of plastic will do (trash can lid..etc)
http://i28.photobucket.com/albums/c244/jiggamanpedro/IMG_1076.jpg

it needed to be shaped little by little to make it fit right. its going to take a little trial and error to get the right fit. but here is what it looked like when i glued it.

http://i28.photobucket.com/albums/c244/jiggamanpedro/IMG_1077.jpg

gorilla glue foams up a little, so i used a dremel sanding tool to sand down the excess glue.
http://i28.photobucket.com/albums/c244/jiggamanpedro/IMG_1078.jpg

Here is what it looks like on the car. I used a #10 self tapping screw and washer (same ones used to hold the sideskirt from the bottom) to hold it all in place.

http://i28.photobucket.com/albums/c244/jiggamanpedro/IMG_1080.jpg