SilviaVsSupra
08-01-2009, 06:44 PM
I am selling a SR20det blacktop that I had swapped into my s13 240sx its a 97 blacktop, the motor is not assembled. it has a lightly spun rod bearing, so it needs a new long block or this one can be rebuilt easily, damage is very very minimal to crankshaft seat only. I purchased the motor from a reputable source with about 40-50k mi on the motor, I only put about 5k miles after it was swapped into my s13. I had the car on a Mustang Dyno and it produced 287whp at 14psi, this number would be a bit over 300 on a DynoJet. also have Dyno sheets available. this was a very stout motor and I am switching plans to an electric conversion.
motor has a some nice mods, everything is in good condition!
mods;
Titanium valve springs and retainers
Taka Stainless oil lines
GT28 Turbo
HKS actuator
harness is already wired for a s13
Spec stage 3 clutch
Megan turbo manifold and dump pipe
if someone is looking to do a swap for cheap this is your spot, pickup a longblock for 3-400$ and you have a sweet sr20 ready to go!
motor has a some nice mods, everything is in good condition!
mods;
Titanium valve springs and retainers
Taka Stainless oil lines
GT28 Turbo
HKS actuator
harness is already wired for a s13
Spec stage 3 clutch
Megan turbo manifold and dump pipe
if someone is looking to do a swap for cheap this is your spot, pickup a longblock for 3-400$ and you have a sweet sr20 ready to go!