PDA

View Full Version : Coldpipe for *updated* version of the S13 Greddy Intake Manifold

om3ga
07-31-2009, 02:44 AM
Im trying to find a coldpipe that works with the new version of the S13 Greddy intake manifold with the slightly longer runners, apparently one is either not made for it yet or i cannot find it http://www.nicoclub.com/forums/images/smilies/frown.gif
RPS13-604
07-31-2009, 02:47 AM
i think ISIS makes one not 100% if not you need to custom one cause dunno why greddy stop making the cold pipe
conrad_s13.5
07-31-2009, 08:03 AM
there is one on enjuku.......and u mean cold pipe right?
om3ga
07-31-2009, 12:12 PM
there is one on enjuku.......and u mean cold pipe right?


Yeah the coldpipe, That one on enjuku does not work with the new style greddy intake manifold that is for the older one :wtc:
blksylv
07-31-2009, 12:37 PM
would an s14 cold pipe work?
om3ga
07-31-2009, 05:54 PM
you tell me? lol i was the one asking questions hehe i hope someone replies to you.
blksylv
07-31-2009, 06:49 PM
idk my friend used one on his isis manifold w/o any probs
om3ga
08-01-2009, 10:01 AM
idk my friend used one on his isis manifold w/o any probs

he ISIS manifold is the same as the older style greddy.
burnsauto
08-04-2009, 02:23 AM
if i can get a hold of a tig welder i can make you one using the old style cold pipe. it prob just needs a little bit of a re-angleing.
om3ga
08-04-2009, 09:52 AM
if i can get a hold of a tig welder i can make you one using the old style cold pipe. it prob just needs a little bit of a re-angleing.


That would be awesome man holy shit haha please do youre awesome.
slider2828
08-04-2009, 10:02 AM
How off is it? Can you use angle couplers like from siliconintakes?
om3ga
08-04-2009, 06:21 PM
I might be able to im not sure yet i havent checked but i think its just a slight angle itd be easier to cut the pipe in half and probably re-weld it after rotating the upper portion a few degrees counter-clockwise.
s15specR
08-05-2009, 09:37 PM
no angle couplers won't work, you need to cut it turn it and weld it, remove the curve piece at the end replace with a straight, and the also chop it down about an inch. The overall cold pipe was a little higher, so two chops a turn and an extension.
om3ga
08-06-2009, 10:22 AM
no angle couplers won't work, you need to cut it turn it and weld it, remove the curve piece at the end replace with a straight, and the also chop it down about an inch. The overall cold pipe was a little higher, so two chops a turn and an extension.

Did you make one of these? If so would you be willing to fabricate one for me? PM me