PDA

View Full Version : NH SR red top, Kaaz 2-way, Tein He + more

s13joe
07-22-2009, 10:44 AM
Red top SR, all wired up and ready to be dropped in. comes with ECU, harness, and tranny along with side mount, rocker arm stoppers, and an almost brand new Exidy stage 1 clutch. -$2000

Tein HE coilovers (s13), not blown, still in good shape, one stud is however missing from the front passenger side but can be easily replaced. never was disappointed with this coil- $650

Kaaz 2-way installed into an s13 pumpkin. locks hard. could use some new oil but nothing to worry about. $700

Megan racing exhaust, 3 inch, down pipe, test pipe and cat back a little beat up round the muff but nothin too serious. -$250
http://i642.photobucket.com/albums/uu145/JoeBartlett_NZ/SDC10613.jpg

Tein Tension rods (s13), in good condition $150
http://i642.photobucket.com/albums/uu145/JoeBartlett_NZ/SDC10628.jpg

Wicked tuning RUCAs (s13) good shape, decent RUCA $60
http://i642.photobucket.com/albums/uu145/JoeBartlett_NZ/SDC10629.jpg

Tein Tie Rods SOLD

Nardi wheel and hub SOLD

Front and rear Strut tower brace (s13), these are not your ebay special braces but these have so weight to them and give a noticeable difference- $75 for the two
http://i642.photobucket.com/albums/uu145/JoeBartlett_NZ/WellyNHfallscarparts132.jpg

parts are located in South NH
shipping will be at the buyers expence
for Pics or any other questions please EMAIL me as i do not check the forum often enough- [email protected]
Team Aero-K
07-22-2009, 11:23 AM
pics would help you know!
rexify
07-22-2009, 11:30 AM
interested in the nardi. Is the hub for an s13 with cruise control?
s13joe
07-22-2009, 12:20 PM
have some pics but dont want to post 56K sized pics and since im internet illiterate i cant figure that out,

dont think the hub is for cruise control, the hub is not the best but the wheel is all good, what would make it different for cruise? i have some pics shot me an email and ill send em to yah, i have a lot of interest in the nardi so it might be gone fast.
c41250n
07-22-2009, 12:57 PM
pics of the strut bars?
rexify
07-22-2009, 01:38 PM
pm sent! I can pick it up if you in NH.
s13joe
07-23-2009, 10:48 AM
Sale pending on Nardi, Tie rods, and strut braces
s13joe
07-23-2009, 03:44 PM
update

Nardi wheel and hub sold, Tein tie rods sold
s13joe
07-24-2009, 09:20 AM
bump for a few pics added
s13joe
07-29-2009, 08:08 PM
bump it up
JRex
08-01-2009, 10:43 PM
How much for the RUCAs shipped to 32608?