PDA

View Full Version : Autoto Manual swap no Fuel


Gjohnson7
07-15-2009, 08:54 PM
Ok, need a little help. I wanted to see if I had my wiring done correctly before I pulled the engine again to check for a slave cylinder leak, so I slapped on the starter and plugged in all the wires. I turn the key and the engine cranks, but I've got no fuel. The fuel pump doesn't turn on or even start priming. Am I missing something. I am doing a auto to 6 speed swap with this conversion, so I did jump the top connector next to the fuse box that was for the Auto Tranny (Neutral position I think) But am I missing something else. I swapped in a Walbro fuel pump a month or so ago, but it's never been tested or anything.

When I jump the fuel pump wire directly to the battey and hear a relay clicking in the driverside foot well. Next to the fuse box. What am I missing, sorry this is my first Auto to 5/6 speed swap as well.

Gjohnson7
07-15-2009, 09:55 PM
--------------------------------------------------------------------------------

I think I know what the problem is. I'm looking a 2 different F3 pinouts and 1 says the 11. is Fuel Pump (FPR) and the other says 11. Fuel Pump Relay (to ECM). I think I'm just powering up the Fuel Pump relay.

Anyone, know what wire on F3 the fuel pump should be wired into?


Also, what is the ECCS relay for? Do I need it when running a stand alone ECU?