Rb25 s13

[flicker]

Up for trade/sale is my Nissan 240sx. I don't have the time or patience to finish it right now, so it has to go.

1993 Nissan 240sx SE Coupe
Silvia Front End / Wingless Trunk
Cusco Coilovers
Cusco Sway Bars
Cusco Strut Bars
Cusco E-Con
Cusco RUCA
Cusco Tension Rods
Nismo Power Brace
Poly Subframe Bushings
RS*R Ex-Mag Exhaust
5 Lug (300zx Front/ S14 Rear)
LSD
Clean Full Grey Interior (one small crack on dash)
Walboro 255
Factory Cluster
Silvia Cluster
R33 Skyline Cluster

Car has no drivetrain in it, everything below needs to be installed.


Nissan RB25DET R33 Skyline Motor
Fresh Rebuild
Nissan Main / ACL Race Rod Bearings (new)
Nissan N1 Water Pump (new)
Nissan Rings (new)
Powder Coated Valve Covers

ACT Clutch (new, 6 puck sprung disk with xtreme pressure plate)
Aftermarket Turbo Manifold (eBay, supplied when I got the motor)
Garrett T3/T04e 60 Trim Turbo (new)
Tial 38mm Wastegate (new)
Factory R33 ECU
Factory R33 Harness
R33 ApexI PowerFC with Controller (new)
Stock R33 GT-S Transmission
McKinney S13 RB Motor Mounts (new)
McKinney S13 RB Swap One Piece Driveshaft (new)

Chargespeed Sport Seat Black (new)
Takata Harness
Works Bell Steering Wheel Short Hub (new)
Works Bell Quick Release (new)
Nardi Deep Dish Steering Wheel (new)

Rays Gram Lights 57 Optimise Time Attack Edition
18x8.5 front and 18x9.5 rear w/tires.


http://img.photobucket.com/albums/v74/flicker/IMG_0086-1.jpg
http://img.photobucket.com/albums/v74/flicker/328221782_a094291c0d.jpg
http://img.photobucket.com/albums/v74/flicker/RB.jpg
http://img.photobucket.com/albums/v74/flicker/2009-06-11121322.jpg

Manifolds need to be bolted on motor, Clutch and transmission need to be bolted on, wiring, and dropped into the car. Rear brake lines need to be connected, it needs an intercooler and a downpipe.

As you can see, there is well over $16k invested in the car, and won't take much to get it running. I'm know I'm not going to get anywhere close to what I have in it. I'm more looking for trades right now, but if you do want to buy the car, make a cash offer.

I wouldn't mind a clean older Lexus LS/GS, but I'm open to all offers.

[lewisfk]

hey how much for the rims?

[flicker]

hey how much for the rims?
Not parting out just yet.

[lewisfk]

i'm in corpus chisti area and i know a few people wanting a project like this! hope to here from u in the near future.

[Popscribble]

I want that power fc ill give you a stock computer with it gimme gimme gimme

[flicker]

I want that power fc ill give you a stock computer with it gimme gimme gimme

As of now, I'll only part out in large pieces. The shell how it sits, and the complete motor/tranny/turbo/ecu setup all together.

[one clean 300z]

1985 toyota rock crawler with 47,000 invested been in petersons 4wheel mag twice
very nice truck pm me please

[Popscribble]

dang it how much for the whole rb setup then?

[flicker]

Nissan RB25DET R33 Skyline Motor
Fresh Rebuild
Nissan Main / ACL Race Rod Bearings (new)
Nissan N1 Water Pump (new)
Nissan Rings (new)
Powder Coated Valve Covers

ACT Clutch (new, 6 puck sprung disk with xtreme pressure platehttp://images.intellitxt.com/ast/adTypes/mag-glass_10x10.gif (http://zilvia.net/f/#))
Aftermarket Turbo Manifold (eBay, supplied when I got the motor (http://zilvia.net/f/#))
Factory R33 ECU
Factory R33 Harness
R33 ApexI PowerFC with Controller (new)
Stock R33 GT-S Transmission
McKinney S13 RB Motor Mounts (new)
McKinney S13 RB Swap One Piece Driveshaft (new)

$4000
$4500 with
Garrett T3/T04e 60 Trim Turbo (new)
Tial 38mm Wastegate (new)

[flicker]

1985 toyota rock crawler with 47,000 invested been in petersons 4wheel mag twice
very nice truck pm me please

I PM'd you. :coold:

[Popscribble]

damn i just want the power fc if you change your mind pm me i can send a stock ecu to keep your car running too so let me know

[lewisfk]

i asked about thoose rims, what it do?

[Popscribble]

will you sell me the power fc it was my birthday on the 24th, itll be the bestest birthday present everrrrrrrr whatya say??????