S14 window won't roll up

[Saviorsoul]

So I bought a new S14 the other day and the driver window won't roll up. I here from a 240 friend that its most likely the window amp, but it however could be the window motor as well. I have a parts S13 and was wondering if the window motor & or amp would be work in a S14.? Or are they different?

[RACETUNE]

So I bought a new S14 the other day and the driver window won't roll up. I here from a 240 friend that its most likely the window amp, but it however could be the window motor as well. I have a parts S13 and was wondering if the window motor & or amp would be work in a S14.? Or are they different?

*they are different. you can make it work but its not worth it.

*First rip the door panel off, get a test light and check if the is power going to the window motor, if there is no 12v then the window switch/amp (same unit) is bad. if there is then the window motor is bad.

*If you do not have the experience, remove your door panel and go to a mom/pops stereo install shop and ask them to check if the window motor is bad and they most likely do it for free.

Good luck!!!

-Frank

[importdude]

depending on your year s14
there will be a amp on early models

take the door panel off and feed 12volt on the motor plug directly that will tell you if the motor is working or not

I can fix your window motor if you send it to me

[rokmplutonium]

The 95' S14 window amp are interchangeable with the S13's

[garagelu]

if it ends up being the window amp. I have a s14 window amp I can sell you. PM me if needed.

[ms bodyman]

So I bought a new S14 the other day and the driver window won't roll up. I here from a 240 friend that its most likely the window amp, but it however could be the window motor as well. I have a parts S13 and was wondering if the window motor & or amp would be work in a S14.? Or are they different?
have someone take your door panel off ,take a booster pack [like what you use to jump a car off with] unplug the window motor use 2 wires with universal electrical connections so the naked wires wont touch put 1 wire on one terminal on the back side of thre motor ,the other on the other terminal on the back side of the motor.connect the other end off the 2 wires to the booster pack 1 to red 1 to black.if it does not work swap the wires on the booster pack end around.if the motor does not do anything it`s the motor .what you do is like you skip everything btween the battery and the motor ,make sure you unplug the motor,

[Saviorsoul]

thanks guys. My 95' was made in Dec 94'. The one from the S13 did the trick fine. :) Took less then 5 minutes to fix