PDA

View Full Version : fuel pump won't work need help


tuner92
04-26-2009, 07:56 PM
I just installed an sr20 in my car and it will crank over it wont get gas or spark, i fallowed the wiring diagram from frsport and the one thing I came across was the the part where you use the ka plugs on the sr harness all the wires mached expet the fuel pump regulater it’s the one with the black wire with the pink strip the ka plug had it but the sr did. I hooked it up to a 12v wire. Is there anything else it could be I realy need help on this. thanks

tuner92
04-26-2009, 10:12 PM
does anyone have any idea what it could be

tuner92
04-27-2009, 03:54 PM
also win i tryed to crank it over the ground on the back of the motor to the fire wall started smoking does any one know what that is caused by

projectRDM
04-27-2009, 06:54 PM
Engine is only grounded through that little wire, you're cooking it. I assume you didn't ground the battery cable to the plenum, or the alternator case to the chassis. You need those too.

The black/pink fuel pump wire on the underhood plug is a signal wire, ground trigger. Not voltage.

tuner92
04-27-2009, 07:07 PM
i grounded the pelunm but im not sure about the alternater

and what wire would be good to hook up to the black and pink wire?

JVD
04-27-2009, 09:37 PM
i grounded the pelunm but im not sure about the alternater

and what wire would be good to hook up to the black and pink wire?

Black/Pink goes to Black/Pink. It's a signal wire that is ground out via the ECU. The other end goes to the fuel pump relay.

tuner92
04-27-2009, 09:51 PM
that was the thing the ka plugs had the black wire withe pink stripe and the sr harness didnt have that wire

JVD
04-27-2009, 09:55 PM
that was the thing the ka plugs had the black wire withe pink stripe and the sr harness didnt have that wire
UGH.

Pin #104 on ECU plug. Trace that wire.

Hook it up to said KA harness wire.

tuner92
04-27-2009, 09:59 PM
UGH.

Pin #104 on ECU plug. Trace that wire.

Hook it up to said KA harness wire.


do you have a diagram or a link to one for the pins on the ecu

tuner92
04-28-2009, 02:51 PM
what is the #104 pin for

tuner92
04-28-2009, 05:45 PM
ok so i got the wire from the #104 pin hooked up and it still wont start

and could it be the igniter chip