WangonwWarrior
04-12-2009, 07:51 PM
PARTS FOR SALE:
- Grey S14 seats- $110
- S14 seatbelts- $40.00
-Metal silvia fender - $100.00
- Black pignose lip with 2 cracks- $60
- complete 5 speed conversion for s13. Good trans with knockoff short shifter and all sensors and connectors intact including good speed sensor and complete lower trans harness that i cleaned the wiring up to, flywheel, used centerforce clutch, lower shift boot, upper shift boot, shift boot trim, clutch pedal, clutch master and slave, clutch hardline, driveshaft, cross member (no you can not use an automatic trans crossmember unless you want 2 bolts holding your trans in). $500.00 obo All you need to buy is clutch fluid and a manual transmission pilot bearing.
KA24DE engine setup
Engine comes assembled the pics are to show its fresh. Stock bottom end, Cylinder head- $500 dollars of machine work done. Decked, valve grind, new valve stem seals, oven straightened, cam lines straight, comes with PERFECT bearing caps and valve tappets. Adjusted to 240/240 cam swap (More low end), cams INCLUDED. this is a complete setup, all machine matched. New timing chains, tensoners, and sprockets, all new gaskets and head gasket, new front and rear seals. I basically overhauled the engine and was going to put it in the s13. Comes with intake manifold, exhaust manifold, all accessories, injectors, EGR blocked off, no belts come with engine. $700 obo
http://i401.photobucket.com/albums/pp91/Wanganwarrior/IMG_0574.jpg
http://i401.photobucket.com/albums/pp91/Wanganwarrior/IMG_0580.jpg
Buy a lot of stuff and get a discount
- Grey S14 seats- $110
- S14 seatbelts- $40.00
-Metal silvia fender - $100.00
- Black pignose lip with 2 cracks- $60
- complete 5 speed conversion for s13. Good trans with knockoff short shifter and all sensors and connectors intact including good speed sensor and complete lower trans harness that i cleaned the wiring up to, flywheel, used centerforce clutch, lower shift boot, upper shift boot, shift boot trim, clutch pedal, clutch master and slave, clutch hardline, driveshaft, cross member (no you can not use an automatic trans crossmember unless you want 2 bolts holding your trans in). $500.00 obo All you need to buy is clutch fluid and a manual transmission pilot bearing.
KA24DE engine setup
Engine comes assembled the pics are to show its fresh. Stock bottom end, Cylinder head- $500 dollars of machine work done. Decked, valve grind, new valve stem seals, oven straightened, cam lines straight, comes with PERFECT bearing caps and valve tappets. Adjusted to 240/240 cam swap (More low end), cams INCLUDED. this is a complete setup, all machine matched. New timing chains, tensoners, and sprockets, all new gaskets and head gasket, new front and rear seals. I basically overhauled the engine and was going to put it in the s13. Comes with intake manifold, exhaust manifold, all accessories, injectors, EGR blocked off, no belts come with engine. $700 obo
http://i401.photobucket.com/albums/pp91/Wanganwarrior/IMG_0574.jpg
http://i401.photobucket.com/albums/pp91/Wanganwarrior/IMG_0580.jpg
Buy a lot of stuff and get a discount