Need help asap!!

[ocska04]

Ok so i have a 1996 s14 with an s14 sr... i have blitz twin disc clutch kit on it and well the throwout bearing gave up on me. So i changed the throwout bearing (i got it from west covina nissan) along with the slave and master cylinder. So i take it out for a test drive and all and about 25 miles of driving it i feel the tranny slip around 70mph and then the clutch lost complete pressure... so i swapped out the master got it from autozone and the slave got it from west co. nissan (nismo slave) now regained pressure but clucth only has pressure about 3/4 of the way down only but it wont go into any gear at all. WHAT CAN THIS BE? any help would work

[Sileighty_85]

make sure system is bleed completely and adj the MC rod

Edit: also check the Piviot ball for the clutch fork, it common it will snap with strong PP

[GREXS14]

Did you bleed the system properly and is it possible you may have bent the clutch fork during the install?



edit beat me to it lol

[ocska04]

i did bleed the system completely... i pump and pump and pump and have buddy open bleeder and fluid comes out with alot of pressure... im positive that i didnt bend the fork when installing the bearing... one thing i did notice when i put it back together was that it would create way more pressure that before cause i had a bad master and slave so now that both were working properly it was building the right amount of pressure

[ocska04]

Anyone else have any ideas what it might be before i drop the tranny