View Full Version : clutch pedal assembly bolts
tinys s14
03-02-2009, 05:34 PM
I bought a clutch pedal assembly and was jus wondering if the assembly requiers any bolts or do they have to be a certain lenght. Its a s14 pedal assemply by the way.
thanks
MrFixIt
03-02-2009, 05:40 PM
The pedal assembly has two long studs attatched to it. All you have to do is run down to ACE and get some nuts to put on the end of em'.
That's for an S13 though. Can't confirm for an S14, though I'd be very surprised if it was different.
simonsays
03-02-2009, 05:51 PM
do you have a picture of this clutch pedal assembly?
i just recently did a 5 speed swap and i had to improvise on my clutch pedal.
apparently for s14's, the part where the long studs are, it has spacers.
dang i shouldve took pics of the swap.
but yea, good luck with the swap.
here are some threads i found that helped me out with the swap.
Auto to Manual Writeup (5 speed conversion): 240SX Technical Forum: Nissan Forums / Infiniti Forums - NICOclub (http://forums.nicoclub.com/zerothread/181139)
S14 Tranny Swap - Electrical Connections (http://www.ka24development.com/cwilfert/S14_tranny_swap_electrical.html)
http://jimwolftechnology.com/wolfpdf/WIRING%2097+%20240SX%20TO%2096%20ECU%20WIRE%20MOD. PDF
projectRDM
03-02-2009, 05:55 PM
M8x1.25 nuts on the firewall side, M8x1.25 bolt through the top of the pedal into the dash. Same as any other pedal.
MrFixIt
03-02-2009, 05:59 PM
M8x1.25 bolt through the top of the pedal into the dash.
Oh yeah, forgot about that one haha. Good call.
It's been a while since I've done the swap, but I'm pretty sure for that bolt I was able to re-use the one that was originaly holding up that green box thing (shift lock control unit or something?) in the area where the pedal was going.
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.