FS: HALTECH E6X w/LS1 Coils - For SR20DET

[RMJmotor]

Guys I have the full Haltech E6X setup off my old Pro AM Drift 240sx.

*** I Accept Cash and Paypal. I will ship, AT BUYER EXPENSE. ***

This is a Full stand alone unit and will need to be reprogramed for your Sr20DET setup.

This setup is complete, pre-wired for the SR20DET Redtop. Includes the following:

- Haltech E6X stand alone ECU
- Full flying lead Harness pre-wired for SR20DET redtop w/ side feed injectors. Will fit stock TPS/ temp / Cam sensors
- LS1 Coils (This will not work with stock SR20 Coils unless re-wire) LS1 coils are much stronger than the stock coils.
- Custom made 8.5mm Magnacor spark plug wires. Made for LS1 to Sr20 Plugs
- 3-bar Map sensor
- Haltech Fuse block
- Air intake temp sensor

http://c3.ac-images.myspacecdn.com/images02/35/l_48a10fc2e3b44b8d8a2a491e5079db16.jpg

http://c3.ac-images.myspacecdn.com/images02/24/l_da6bb6c7cfc1490bb8251177ba6cb96a.jpg

This is the Haltech installed in he car:

http://c1.ac-images.myspacecdn.com/images02/9/l_e80c64f445224e18b510f088587fda78.jpg

Basically just ditch you old harness and ECU, run the new harness, run power and ground to the Fuel pump. Plug in the injectors, coils and sensors, program, and go.

I will ship, Retail on this ECU is over 1300.00 and that does not include making the harness or installation, LS1 coils new are about 200 and you need to wire and make the cables.

$1225.00 SHIPPED (to lower 48 states) **if you pay by PAYPAL please add 3%**


Contact me with any Questions.

[RMJmotor]

Middle of the Week BUMP!!

Guys this is as pug n play as a stand alone can get for the SR20

[RMJmotor]

Weekend bump, this is a great set up guy all wired and ready to go