Built RB26..AEM EMS HELP!

[rb26needaparachute]

Ok I have a AEM EMS with a built RB26,Tomei type B cams,Precision PT6776HPS turbo,RC 1000cc injectors and my fuel regulator is as low as I can get it(35lbs) amd 2 in tank walbros.My AEM UEGO is reading like 10.1..super rich dumping gas and fouling plugs and potentially washing bearings and rings out. Ive looked everywhere and cant find how to change the fuel table and lean my air/fuel ratio? Does anybody know how to do this?.. If so please be specific as this is a lot harder then I anticipated,lol. Also if any of you has a close/similar setup please send me the .cal file to me. ANY help will be much appreciated! Thanks,Jay email [email protected]

[Monooxide]

If you have the software installed you should be able to go into help and view the manual for the ECU so you can figure out what you need. I also think that aempower.com has a Manual in the download section.

I know in my ECU theres a section called Volumetric Efficiency Table and that is the fuel adjustment. The higher the number the more fuel... good luck!

Im not sure how the AEM works, if it has a wizard Id use that and make sure that your Injector Offset time isn't too high. I would try to walk your Injector offset time nearer to 0 and your Time for one Gama to 7.5. I may speaking greek in terms of AEM but that's how I know it.

[steve shadows]

Make sure you are using the right AEM Pro SOftware

NEXT!!!

Make sure you go to "Configuration" and set the TPS up

Next you will want to make sure you do the Injector SETUP and select the right type of injectors you are using from the make/model list AEM software provides you to pick from

Make sure you selected what injectors you are using.

Open it - connect with your ECU through your laptop.

Now go to "FUEL" top menu

Then go to "MAP"

Then go to "TABLE"

Now adjust cells accordingly. to bring fuel down.


Other than this, take it to a reputable tuner and have it all taken care of the right way before you break something

[rb26needaparachute]

I really appreciate the help..Ill write if I have any probs..I cant seem to get any help on the aem forums..thx again Ill keep you posted

[eh?]

I'm guessing your running on the base map and have not even changed the injector size?
Follow steve shadows steps and then right click on the fuel map and on the bottom of the list you will see the option to change fuel size/pressure...

[rb26needaparachute]

Ive changed the injectors and map in the options when I first got laptop for the AEM but Its super rich. Ill try to lower the fuel later today and let you guys know.

[eh?]

Can you take a screenshot of your fuel map?

[rb26needaparachute]

Sure ill post it tomorrow...thx for you help.