bleeding failed

[shytdoode]

iv bench bleed the clutch master cylinder and i have tried bleeding it from the slave cylinder yet i still have no pressure im getting really frustrated now:rant::rant::rant::rant:-_- any suggestions?

[DreamN]

do you still have the dampener thingamabob? if so, that might be your issue.

[alzahakar]

Keep bleeding. Or you can take that stupid loop out of the system.

Here's how: Clutch Line Modification - Removing Damper Loop - zeroyon.com (http://www.zeroyon.com/index/content/view/32/47/)

At the last step, where you have to bend the line, go buy a line bending tool. They are cheap and keep you from having to replace the entire hard line.

[MadMaverick]

Is this a new master or are you trying to solve a problem by bleeding? How about the slave?

[MadMaverick]

Just saw your other thread. If its properly connected and you have gone through 2 bottles of brake fluid, then you have a leak somewhere. Remove the dampening box like the others said 5 times and re-bleed.

[shytdoode]

well that was befor i bench bleed the clutch master but now there is no leaks bench bleed and should be fine but isnt -_- is the dampening loop the box that connects from the clutch line to the slave cylinder line?

[MadMaverick]

5 seconds of google magic yeilded this:

THE GARAGE GUIDES - Remove Your Clutch Damper (http://garage.projectraine.com/content_guides/240_clutchdamper/clutchdamper.html)

[shytdoode]

will try this tomorrow and will update this seems like it should solve the problem