jdmae86
01-08-2009, 06:35 AM
Located in Greensboro, NC
My car is pretty much almost complete... The car really needs a body kit/widebody fenders & Dyno Tune(I street tuned this car myself and I'm sure it could make more power) to be done... I used the IGN Base map on the Power FC so there is awesome potential for more power.
I started this project in May 08... I said this was going to be the last car I built for a couple years but I think i'm done with fast cars. I do not want this car to go to some 16 yr old bc it would be a rolling coffin... This is not a normal everyday car. Its more a unfinished race (http://www.vadriven.com/forums/showthread.php?t=267622#) car then anything. The Wiring is all custom(fuse panel, relays, power hidden in the air bag compartment)... The body & paint are not in the best shape. There is a large dent in the pass rear quarter panel. The car would be perfect for someone that wants overfenders. I had plans to put full kit and overfenders on the vehicle when I purchased it, thats why I didnt care about the rear dent. The car has no a/c but has awesome heat.
Car is running 22lbs of boost.. When it was running 18lbs the car made 411rwhp... I do not know how much its making now. But the car is scary fast... lol
I built this car to be a track/drift/wkend fun car. The car has been my daily for the past couple months & doesnt even have 2,000 miles since I swapped the motor.
Also I have listed 300zx calipers & Nismo 550cc Injectors. Neither of them are installed on the car but well come with the car. 300zx(28mm) calipers bolt right up... there are tons of guides on how to install them. The injectors are just as easy. I was going to wait until I got the car dyno tuned to install the injectors.
Also the car has a Clifford 2way Car alarm. 1 remote with the digital screen that tells you whats going on with the car & 1 normal 4 button remote. I also installed motion sensors on the car for the alarm. I have a tilt sensor for the alarm but its not installed.
Why I'm selling it... I need $ to start a small business
$14,000 OBO
I think 14k as is is not a ridiculous price for a unfinished 400whp+ car... Just look at the cars on ebay and selling on other nissan (http://www.vadriven.com/forums/showthread.php?t=267622#) forums. I have alot more $ tied up into vehicle but I need it gone.
______Engine:______
RB25det Series II w 5sp Trans(Timing Belt, Tensioner & water pump replaced around 1000 miles ago)
ACT Stage 3 Unsprung Clutch
Sard Fuel Pressure Regulator
Garrett T3/T4 60 Trim 63 A/R
Apexi Power FC Standalone ECU w/ Commander
FC Datalogit
Z32 Maf
Q45 Throttle Body
Custom Turbo Heat Sheild
Tial 38mm Wastegate
HKS SSQV
Nismo 550cc Injectors
Top Mount Exhaust (http://www.vadriven.com/forums/showthread.php?t=267622#) Manifold
Buick (http://www.vadriven.com/forums/showthread.php?t=267622#) Grandnational Coil
Accel Plug Wires
300zx Ignitor
Exhaust Heat Wrap
31x12x3 FMIC Intercooler
Custom Intercooler piping w/ T-bolt Clamps
Greddy Intake
Engine Bay (http://www.vadriven.com/forums/showthread.php?t=267622#) Painted
Braided Clutch Line
Walbro 255 Fuel Pump
Rucus Racing Mounts
Custom Driveshaft
Koyo Radiator
(2) V-Band Mild Steel Flange Kits / o2 Sensor Bung
Custom Downpipe & wastegate exhaust
3" Cat-back Exhaust
New Clutch Master Cyclinder
Braided Clutch Line
Altima Electric Fans
Earls AN -4 Fuel Line
Earls AN -6 PS Line
Earls AN -6 Turbo Drain Line
______Interior:______
Autometer 4497 Tach
Autometer 4488 MPH
Autometer 4315 Fuel Level
Autometer 9117 Tach Adapter
Autometer Oil Pressure
Autometer Coolant Temp
AEM Uego Wideband
Nylon Tubing Kit
Aluminum Battery Relocation Box
Push Button Start
4 gauge Battery Wire
600 Ft 14 Gauge Wire
12 Fuse Panel
80Amp Circuit Breaker
10 30amp Relays
Kognition Design Carbon Fiber Panels
Custom Carbon Fiber Switch Panel w. Switches
Battery Kill Switch
Power Distribution Block
S14 Radio Bezel Panel Delete
S14 Gauge Cluster Delete
New OEM Shifter Console
Kenwood CD MP3/WMA Player
______Footwork/Suspension/Exterior:______
Rota P45R 18x9.5 Wheels
HKS Hiper Coilovers
Fleabay Toe and Camber arms
300zx 4 Piston Calipers
Kouki OEM Sideskirts
Zenki OEM SE Front Lip
8000k Low Beam HID's
5 Lug Conversion
5 Lug Rotors
Gorilla Lug nuts
Brand New Windshield(yes if you ever get one you well understand)
I'm sure there is more but I can't remember everything
I have a ton of pictures on the car & well post more later(at work & cant access photos). I have pictures of the entire build. Also have a video of the first time I cranked the engine.
Also if paid with a personal check I well hold the vehicle & title until everything has cleared OR we can test drive the vehicle to the bank for a wire transfer/cashiers check. I do not let people use my license plate to drive the vehicle home(burned twice now).. so some kind of transportation should be prearranged prior to pickup.
http://img.photobucket.com/albums/v92/jdmae86/s14rb25/IMG_2547.jpg
http://img.photobucket.com/albums/v92/jdmae86/s14rb25/IMG_2601.jpg
http://img.photobucket.com/albums/v92/jdmae86/s14rb25/IMG_2598.jpg
http://img.photobucket.com/albums/v92/jdmae86/s14rb25/IMG_2599.jpg
http://img.photobucket.com/albums/v92/jdmae86/s14rb25/IMG_2610.jpg
My car is pretty much almost complete... The car really needs a body kit/widebody fenders & Dyno Tune(I street tuned this car myself and I'm sure it could make more power) to be done... I used the IGN Base map on the Power FC so there is awesome potential for more power.
I started this project in May 08... I said this was going to be the last car I built for a couple years but I think i'm done with fast cars. I do not want this car to go to some 16 yr old bc it would be a rolling coffin... This is not a normal everyday car. Its more a unfinished race (http://www.vadriven.com/forums/showthread.php?t=267622#) car then anything. The Wiring is all custom(fuse panel, relays, power hidden in the air bag compartment)... The body & paint are not in the best shape. There is a large dent in the pass rear quarter panel. The car would be perfect for someone that wants overfenders. I had plans to put full kit and overfenders on the vehicle when I purchased it, thats why I didnt care about the rear dent. The car has no a/c but has awesome heat.
Car is running 22lbs of boost.. When it was running 18lbs the car made 411rwhp... I do not know how much its making now. But the car is scary fast... lol
I built this car to be a track/drift/wkend fun car. The car has been my daily for the past couple months & doesnt even have 2,000 miles since I swapped the motor.
Also I have listed 300zx calipers & Nismo 550cc Injectors. Neither of them are installed on the car but well come with the car. 300zx(28mm) calipers bolt right up... there are tons of guides on how to install them. The injectors are just as easy. I was going to wait until I got the car dyno tuned to install the injectors.
Also the car has a Clifford 2way Car alarm. 1 remote with the digital screen that tells you whats going on with the car & 1 normal 4 button remote. I also installed motion sensors on the car for the alarm. I have a tilt sensor for the alarm but its not installed.
Why I'm selling it... I need $ to start a small business
$14,000 OBO
I think 14k as is is not a ridiculous price for a unfinished 400whp+ car... Just look at the cars on ebay and selling on other nissan (http://www.vadriven.com/forums/showthread.php?t=267622#) forums. I have alot more $ tied up into vehicle but I need it gone.
______Engine:______
RB25det Series II w 5sp Trans(Timing Belt, Tensioner & water pump replaced around 1000 miles ago)
ACT Stage 3 Unsprung Clutch
Sard Fuel Pressure Regulator
Garrett T3/T4 60 Trim 63 A/R
Apexi Power FC Standalone ECU w/ Commander
FC Datalogit
Z32 Maf
Q45 Throttle Body
Custom Turbo Heat Sheild
Tial 38mm Wastegate
HKS SSQV
Nismo 550cc Injectors
Top Mount Exhaust (http://www.vadriven.com/forums/showthread.php?t=267622#) Manifold
Buick (http://www.vadriven.com/forums/showthread.php?t=267622#) Grandnational Coil
Accel Plug Wires
300zx Ignitor
Exhaust Heat Wrap
31x12x3 FMIC Intercooler
Custom Intercooler piping w/ T-bolt Clamps
Greddy Intake
Engine Bay (http://www.vadriven.com/forums/showthread.php?t=267622#) Painted
Braided Clutch Line
Walbro 255 Fuel Pump
Rucus Racing Mounts
Custom Driveshaft
Koyo Radiator
(2) V-Band Mild Steel Flange Kits / o2 Sensor Bung
Custom Downpipe & wastegate exhaust
3" Cat-back Exhaust
New Clutch Master Cyclinder
Braided Clutch Line
Altima Electric Fans
Earls AN -4 Fuel Line
Earls AN -6 PS Line
Earls AN -6 Turbo Drain Line
______Interior:______
Autometer 4497 Tach
Autometer 4488 MPH
Autometer 4315 Fuel Level
Autometer 9117 Tach Adapter
Autometer Oil Pressure
Autometer Coolant Temp
AEM Uego Wideband
Nylon Tubing Kit
Aluminum Battery Relocation Box
Push Button Start
4 gauge Battery Wire
600 Ft 14 Gauge Wire
12 Fuse Panel
80Amp Circuit Breaker
10 30amp Relays
Kognition Design Carbon Fiber Panels
Custom Carbon Fiber Switch Panel w. Switches
Battery Kill Switch
Power Distribution Block
S14 Radio Bezel Panel Delete
S14 Gauge Cluster Delete
New OEM Shifter Console
Kenwood CD MP3/WMA Player
______Footwork/Suspension/Exterior:______
Rota P45R 18x9.5 Wheels
HKS Hiper Coilovers
Fleabay Toe and Camber arms
300zx 4 Piston Calipers
Kouki OEM Sideskirts
Zenki OEM SE Front Lip
8000k Low Beam HID's
5 Lug Conversion
5 Lug Rotors
Gorilla Lug nuts
Brand New Windshield(yes if you ever get one you well understand)
I'm sure there is more but I can't remember everything
I have a ton of pictures on the car & well post more later(at work & cant access photos). I have pictures of the entire build. Also have a video of the first time I cranked the engine.
Also if paid with a personal check I well hold the vehicle & title until everything has cleared OR we can test drive the vehicle to the bank for a wire transfer/cashiers check. I do not let people use my license plate to drive the vehicle home(burned twice now).. so some kind of transportation should be prearranged prior to pickup.
http://img.photobucket.com/albums/v92/jdmae86/s14rb25/IMG_2547.jpg
http://img.photobucket.com/albums/v92/jdmae86/s14rb25/IMG_2601.jpg
http://img.photobucket.com/albums/v92/jdmae86/s14rb25/IMG_2598.jpg
http://img.photobucket.com/albums/v92/jdmae86/s14rb25/IMG_2599.jpg
http://img.photobucket.com/albums/v92/jdmae86/s14rb25/IMG_2610.jpg