Factory Kouki 180sx side skirt body clips

[shinhed]

Long story short, my car is finally in the body shop and they want part numbers to do it right. Where can I get Kouki 180sx part # info?

I know you can get away without all of the proper hardware, but I don't want to.

[94_240sx]

Hardwares come with the side skirts. I doubt that you get them separately. I know it cuz I also tried before. I have full hardwares for my side skirts, and it was really hard to find all of them. They are discontinued in Japan, so I'd say just fabricate them.

[FRpilot]

anyone have a diagram of how they go on? i assume they are like the 91-93 chuck bumper extension pieces, where the body/fender is drilled to attach a female clip so that the male clip on the sideskirts can snap into them.

[94_240sx]

anyone have a diagram of how they go on? i assume they are like the 91-93 chuck bumper extension pieces, where the body/fender is drilled to attach a female clip so that the male clip on the sideskirts can snap into them.

No drilling required. Hardwares look like this. There are 2 more metal clips holding rear fender inside of side skirts. You can find used hardwares, but most of them are rusted really bad. These are not kouki, but should be similar.
http://i126.photobucket.com/albums/p112/sxj6151/NICO2/side2.jpg
http://i126.photobucket.com/albums/p112/sxj6151/NICO2/side1.jpg
http://i126.photobucket.com/albums/p112/sxj6151/NICO2/IMG_5597.jpg

[landins13]

anyone have kouki 180 sides they want to sell?

[BoostedCoupe]

+a million for calling them kouki side skirts instead of "type x".

[shinhed]

Hardwares come with the side skirts. I doubt that you get them separately. I know it cuz I also tried before. I have full hardwares for my side skirts, and it was really hard to find all of them. They are discontinued in Japan, so I'd say just fabricate them.
From the pics you posted, 180sx Kouki mounts are different.

[projectRDM]

In the rear fender well you can use the S14 Kouki sideskirt clips, they're actually the same for all S13/S14. It looks like a standard speaker 'J clip', the ones that reinforce a door panel when screwing into it, but much longer so that it grabs the fender well lip. Any dealer can source it out easily.

[lilpiton]

I know this is an old post , but anyone know how I can make the pictures in above visible?? Imsorting some of the clips and want to see some pictures. I having problems see pictures for older posts...

[afishysilvia]

I know this is an old post , but anyone know how I can make the pictures in above visible?? Imsorting some of the clips and want to see some pictures. I having problems see pictures for older posts...

http://chicagoarea240sx.editboard.com/t3010-180sx-kouki-side-skirt-install-question

Maybe this helps

[lilpiton]

http://chicagoarea240sx.editboard.com/t3010-180sx-kouki-side-skirt-install-question

Maybe this helps

Yes helped out a lot!!!!
Thanks!