S13 silvia sr20 part out!!!

[slamed_s13]

Ok, I need to keep going to school so all this needs to go ASAP! My loss is your gain.

Brief info;
Chassis: S13 with the Silvia front end conversion
Body Style: Vertex Bodykit
Engine: SR20DET Blacktop
Location: San Antonio, TX
Contact: (210) 645-0946 (no later than 12am please)

Ok, Here is the parts-list

Internal Parts:


SR20DET Blacktop (short block, getting a blow by, the motor needs a rebuilt) - $500
SR20DET Tranny - $300
Stock 370cc injectors - $50 - SOLD
Stock Fuel lines - $35
Stock Intake Manifold -$130
Harnesses - $160
Alternator - $65
Powersteering - $65
Brackets - throw me an offer
Battery Relocation Kit (to the trunk) - $70
Koyo Radiator - $150 - SOLD
Flex A lite Dual Electronic Fans - $90
GT2871R (ar.64) with Megan Tubular, Greddy Elbow, T28 intake pipe, and Stainless Turbo Lines w/T28 oil drain tube (the turbo has about 10,000 miles, no shaft play, perfect condition!) - $1,500 FIRM
Intercooler piping w/intercooler with Greddy type RS BOV - $350
NGK Spark Plugs (Heat range 7) - $25 - SOLD

Electronics


HKS turbo timer II with the plug&play harness - $85
AEM electronic boost controller (the plastic part is deformed due to heat from the sun but no one will notice because it will be in the gauge pod. works perfectly) - $200
Prosport Boost gauge - $35

Exhaust


Striaght pipe, megan downpipe & megan 3in racing exhaust. (fully exhaust system, from the downpipe to the tip of the exhaust) $380 firm

Suspension & Drive Train Parts


Fully adjustable Megan Coilovers with the tool to adjust it - $650 FIRM - PENDING
Light Weight Drive Shaft (steel) - $350
ACT 6 Puck Sprung Clutch Disc (7,000 miles on it) - $85

Interior & External Parts


I am looking forward to sell it as a Rolling Chassis. The interior is very clean, uncracked dash, JDM gauge cluster, and S14 seats. The exterior is in fair condition. The passenger side's side skirt is missing a good chunk of piece. Also you might want to get a new front bumper because I scraped a lot since I had the car low. Other then that, the shell is clean, it's got the silvia front end conversion with the vertex body kit, all you need is a little bit of body work and a paint job. If you're planning on installing a front mount intercooler then it's perfect, the piping holes in the chassis has already been drilled. All you need it a motor and a paint job. I will also include the rims and tires. I've got 18s, I don't know what kind of brand it is but it says "REV" on the cap. They're clean rims. Like I said, it is a rolling shell. In addition, the rotors are drilled so that's also a plus. Comes with the full breaking system. All you need is a motor and a paint job!! I will let them go for $2500.


If the part is not listed above, just let me know, I just listed them all off top of my head. As far as engine and inteior&exterior part out, I'm going to have to see how many people are actually interested. But I prefer selling them as I listed above. Only Paypal payment and cash in hand are accepted. No trades please. I will sell the whole car (yes that's everything) for 5,800. The car is still in running condition.

Thanks for looking

Here's some pics;

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0381.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0447.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0446.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0360.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0378.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0803.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0804.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0805.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0808.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0823.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0826.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0834.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0838.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0840.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0841.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0843.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0826.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0443.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0856.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0857.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0859.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0861.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0863.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0847.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0848.jpg

http://i448.photobucket.com/albums/qq208/silver236936/CIMG0849.jpg

[TOMKAIRA93]

are you willing to sell the greddy elbow separately? if yes, how much? Where in San Antonio?

[slamed_s13]

sorry but Not as of right now, I am trying to sell it as a set. But if there is no buyers then I will part out later.

Thanks.

[chvybeatsford]

pic of boost controler and all that's with it. [email protected]com thanks

[jrocslider]

how much for the complete SR?

[slamed_s13]

complete SR for $1200. Like I said, it needs to be rebuilt. I was getting a blow by. I believe piston #2 is gone. That will include everything except the GT2871R special that's listed above. Harnesses, powersteering, alernator, intake mani, fuel lines, injectors, tranny...etc..are all included.

[angledriven]

coilovers 600 shipped . pm me

[jj18extreme]

dibs on 370cc injectors&NGKspark-plugs pay-pal ready....

[slamed_s13]

I might consider trading the whole thing for 06&up GSXR-750 or 600 and R6. Also 05&up 600rr. Preferably red, black or blue.

[slamed_s13]

Ok, seriously...money talks and BS walks....I've had this one guy that's willing to trade me his R1 however, all the sudden he lost contact with me. I called, no answer. I messaged, no reply. I am a legitimate seller with no BS! So please do not waste not only my time, but anyone else's time.

The parts are still up for sale! If no one is willing to buy the ROLLING shell or the short block, i am going to part them out. The rolling shell doesn't include the coilovers, I will take them out and put the stock ones in however, I will take $3,000 if you want the coilovers with the rolling shell.

Thank you.

[Hailtothesilvia]

is this still for sale?

pm sent

[whats_a_sr20]

need interior hit me up!