JEDIs13
12-02-2008, 04:06 PM
I am having trouble getting my trans back in place,
the input shaft is in but there is about an inch gap between the trans and block.
i made sure my flywheel, clutch, and pressure plate where straight with the alignment tool..
i have tried turning the gear that goes to the driveshaft and nothing..
if anyone is close to Riverside, CA i would greatly appreciate some help..
lmk we can work out some sort of deal.. cash or parts
the input shaft is in but there is about an inch gap between the trans and block.
i made sure my flywheel, clutch, and pressure plate where straight with the alignment tool..
i have tried turning the gear that goes to the driveshaft and nothing..
if anyone is close to Riverside, CA i would greatly appreciate some help..
lmk we can work out some sort of deal.. cash or parts