my 89 sr hatchback

[fcdrifter20]

PRICE DROP 5,500OBO (I NEED THIS CAR GONE)

time has come to sell my ride:ugh:. i dont want to do this but i got to help my parents pay the house payments. and im in debt up to my neck.

cars is and 89 hatch back, stock motor was swapped out for sr.has power steering, no a/c and is registerd..and i just replace pistons and rings
car runs and handls grea. anyone who has seen or driven my car can vouch for me when i say that the car runs realy stong, it's easy to drive,and has plenty of power to play with.:bigok:

i pulled the motor out of a clip that read 40k in the gauge cluster about a year ago. so thats about 30ish thousand miles on it. i have put about 7-9thousand miles on it since. here is a list of parts the car has.if u r intersted in the car, plz come see it and drive it in person. i am a regualr at the zorbas meet and that would be the best place to catch me. i dont have my cell anymore so u can call my house its 951-686-5474 ask for danny,if i cant answer plz just leave amessage, or just pm me here

ENGINE
redtop sr20det motor with about 40ish thousand miles on it
Tomie sr20det typa valve springs(installed by cylinder head tech)
Tomie sr20det valve spring sheets(installed by cylinder head tech)
Tomie sr20det valve spring retainers(installed by cylinder head tech)
5angle valve job(done by cylinder head tech in riverside)
light port(done by cylinder head tech in riverside)
oem head gasket(brand new)
oem water pump( brand new)
CP stnd pistons(brand new)
cp piston rings(brand new)
Greddy M-spec fmic
Greddy fmic piping
Koyo 3"inch radiator w/ dual fans(and stcock fan shroud)
Deathwreck 555cc injectors
Walboro 255 lph fuel pump
z32 fuel filter
HKS GT2540 turbo
HKS mushroom filter
z32 mass air flow sensor
Greddy type rs bov
Megan exhaust manifold wrapped with dei headr wrap
Megan 3" turbo outlet
Blitz 3"down pipe
Blits3" exhaust but the end was cut off an replace
A-spec 3"blast pipes
Megan oil catch can
ACT 6puck clutch and pressure plate

SUSPENSION/BRAKES
Tien Super Street coil overs
Tein pillow ball upper mounts(replaced about 2 months ago)
Megan inner tie rods
Megan tie rod ends
Megan rear uppr cntrl amrs
Megan front uppr strut bar
Megan rear upper strut bar
Megan lower tie bar
Megan tension rods
180sx front break calpiers
project mu front brake pads(almost done)
project mu rear breaks pads(about 50%left)
Kazz 2 way lsd

EXTERIOR
Sport max 501's
Falken ziex 912's
pignose lip
180sx replica rear valances
car is red and has some rear qt panel damage to the right rear panel, but isn't realy noticable till u get close, aslo has a dent on the front of the hood, and a couple of ding and dents here and there

INTERIOR
interior is all stock except for e brake button.all seats an panels r there. interior is very clean and dash only has two cracks right above gauge cluster

ELECTRONICS
Apexi SAFC-II
Greddy turbo timer
Megan boost gauge(reads in pounds)

http://i172.photobucket.com/albums/w22/fcdrifter20/IMG_3259.jpg
http://i172.photobucket.com/albums/w22/fcdrifter20/IMG_3256.jpg
http://i172.photobucket.com/albums/w22/fcdrifter20/IMG_3249.jpg
http://i172.photobucket.com/albums/w22/fcdrifter20/IMG_3251.jpg

http://i172.photobucket.com/albums/w22/fcdrifter20/IMG_3257.jpg
http://i172.photobucket.com/albums/w22/fcdrifter20/IMG_3253-1.jpg
http://i172.photobucket.com/albums/w22/fcdrifter20/IMG_3255-1.jpg

[fcdrifter20]

early morning bumps

[fcdrifter20]

bump numer two!!

[Driven08]

Any extra parts included?

[Grenade180sx]

bump for a good friend of mine, this car has balls, it may not be the sexiest looking thing but it smashes and is very reliable. bump for danny imma see if my pops wants thisss

[fcdrifter20]

thnx girl. but ya, i have a lot of stock supernsion parts that i will throw in with it. some extra tires, and some other parts i got lying around for sr20 motors.and a spare 501 to mach the others

[xllivillx]

trade?
http://zilvia.net/f/sale-items/222492-fs-tw-master-tech-tool-set-uber-cheap.html

[fcdrifter20]

no thnx man.i realy need the cash right now