CA18DET GUYS! need HELP! on bee R rev limiter wire pin install

[204JDM240]

hi i cant find out what pins the RPM Signal and Ignition signal are on a ca18det ecu? can someone post a pic or tell me what pins they connect to?? and if u can tell me what colors the wires are thanks!

im looking around and i think pin #45 is the ignition signal but can someone confirm this? it says its an ignition switch i dunno if the same.

According to Bee-racing the wires are :
Red wire: 12V+
Black wire: Earth
Yellow wire: RPM Signal
Green wire: Ignition signal.

[204JDM240]

ive went here and tryed to understand it but still is very confusing for me on the pin outs Drifting Tools and Resources | Driftworks | Bee-R Rev limiter fitting guide (http://www.driftworks.com/resources/bee-r-rev-limiter-fitting,16.html)

[satal95]

Here you go

ImpactBLUE: CA18DET Reference: E.C.C.S. Connector Wiring (http://www.impactblue.org/content/display.php?page=caref.eccs_connector_wiring)

[204JDM240]

pin #45 B/R to Ignition Switch via E108 via E8/F8 is the ignition signal right? sorry still need to confirm lol