PDA

View Full Version : Firewall


A Dying Devotion
01-20-2003, 10:44 PM
Anyone know where I can drill a hole on the drivers side firewall. I need to run a wire from the batt to the rear and have to go through on this side since I ran my RCA's on the other. So just let me know where it is safe to drill. Pics would be a major bonus help.

Jeff240sx
01-20-2003, 10:58 PM
What gauge wire? If you look closely near the master cylinder, to the left (from the front of the car) and a little down, you will see a circular indent. I have a grommet and hole there for my boost gauge and some wires.
-Jeff

A Dying Devotion
01-21-2003, 06:27 AM
big stuff 4 guage. will it still fit their?

Kreator
01-21-2003, 08:12 AM
edit: Hmm nm. I missed "driver's side" part :(

mrdirty
01-21-2003, 08:56 AM
do a search, we covered this a few times a while back.

Jeff240sx
01-21-2003, 09:08 AM
If you can find a drill and grommet big enough, sure it'll fit. Just look for the circular indent. It'll come out right near the gas pedal.
-Jeff

A Dying Devotion
01-21-2003, 11:46 AM
Ok great im gonna attempt this today ill post pics of my system when im done. I am also gonna register my car so I can drive it today wohoo! Have a great day guys.

tmerrick
01-21-2003, 12:07 PM
http://www.tylermerrick.com/240SX/engine/enginebay_after_2.jpg

If you look under the wiper motor and to the left of the brake lines you will see 3 grommets. I just used those although if you have AC they might not be open.