PDA

View Full Version : what's needed for 5 spd swap?

westcoastbadboy23
09-13-2008, 10:57 AM
can someone make a COMPLETE list of what's in need for a 5 speed swap for a ka24de? thanks
shawn240sx
09-13-2008, 11:12 AM
search.....on here or nico.
xxsptcuztomsxx
09-14-2008, 05:27 PM
wrong section...
vodka2
09-14-2008, 06:00 PM
you need a cluth pedal .. and many more other parts.. i have one laying around 25$
westcoastbadboy23
09-14-2008, 07:59 PM
i'd figure this would be a suitable section, since i WTB these parts anyway
enjoisk8board891
09-14-2008, 08:12 PM
ive got a DOHC 5 speed ecu out of a s13 if ya want it. let me know
nissanwarrior
09-14-2008, 08:13 PM
hmmmm....5 speed transmission, flywheel, and clutch!
Phlip
09-14-2008, 08:52 PM
hmmmm....5 speed transmission, flywheel, and clutch!
And hardlines, and master/slave cylinders, sensors and shit...
Searching answers these questions, I know they did when I needed them a few years ago.
flawlessflo3190
09-15-2008, 12:43 PM
ive got the complete set up.....minus the tranny.....pm me thanks
Z_Spool
09-15-2008, 05:42 PM
Nico Tech section listings has two DIY's including parts listings.

Auto to 5sp Swap (http://www.nicoclub.com/articles.php?id=183606)

Another Auto to Manual Swap (http://www.nicoclub.com/articles.php?id=210410)

- 5-speed transmission
- 5-speed crossmember
- 5-speed driveshaft
- Flywheel and MT bolts (marked "MT")
- Clutch and pressure plate
- Release bearing
- Master and slave cylinders
- Hardlines and rubber line from master to slave cyl.
- Clutch pedal
- Brake pedal (optional)
- Boots and brackets for shifter assembly
- Lower wire harness


Search and you shall gain knowledge. ;)

(oh, and btw... keeping the AT ecu gives you a better fuel map producing more power, eliminates the speed limiter, and raises your rev-limiter about 600rpms (IIRC) over the MT ecu. food for thought)
racepar1
09-15-2008, 10:49 PM
My buddy has a COMPLETE swap. PM me if you are interested.
sideways performance
09-16-2008, 12:15 AM
- 5-speed transmission
- 5-speed crossmember
- 5-speed driveshaft
- Flywheel and MT bolts (marked "MT")
- Clutch and pressure plate
- Release bearing
- Master and slave cylinders
- Hardlines and rubber line from master to slave cyl.
- Clutch pedal
shifter assembly thats all thats needed u can make it work alot of ways i can do the 5 speed for u if u want for a pretty penny
westcoastbadboy23
09-17-2008, 11:27 AM
good lookin out everyone!